Cenmax Group U.S.A. CMXT601 Manual Do Utilizador
2005 NEW PRODUCT PROPOSAL
CPX 2350
Description: 2 channel alarm with dual polarity door locks, trunk/hatch release, dual stage shock
sensor, starter disable output, 20 watt single tone siren, mini-transmitters.
B.O.M.:
CPX 2350
Description: 2 channel alarm with dual polarity door locks, trunk/hatch release, dual stage shock
sensor, starter disable output, 20 watt single tone siren, mini-transmitters.
B.O.M.:
1- Main Unit
2- mini-transmitters at 433.9 MHz.
1- 20 watt six tone siren (SN3541 20 watt single tone- Same as Auto Page standard)
1- dual zone shock sensor
1- valet/override switch
1- LED with white plug
1- 3-pin plug for dual polarity door lock/unlock outputs (same as Auto Page standard)
1- Multi-pin alarm wire harness
1- 5-pin standard power harness
1- 2-color box (Auto Page to provide the design)
1- Manuals for Operations and Installation (English and Spanish)
2- mini-transmitters at 433.9 MHz.
1- 20 watt six tone siren (SN3541 20 watt single tone- Same as Auto Page standard)
1- dual zone shock sensor
1- valet/override switch
1- LED with white plug
1- 3-pin plug for dual polarity door lock/unlock outputs (same as Auto Page standard)
1- Multi-pin alarm wire harness
1- 5-pin standard power harness
1- 2-color box (Auto Page to provide the design)
1- Manuals for Operations and Installation (English and Spanish)
Specifications:
1. 500 milli-amp output for starter disable (ground while armed)
2. 500 milli-amp output for door lock/unlock outputs
3. 200 milli-amp output for 2
2. 500 milli-amp output for door lock/unlock outputs
3. 200 milli-amp output for 2
nd
channel trunk release
4. Dual polarity parking light with 2 fuses (one for main power / one parking light
power input) on the 5-pin power harness.)
5. On board parking light relay (same as Auto Page standard)
Programming:
PROGRAMMING:
Note: This system can keep up to 4 remote transmitters in its memory. If more than 4 transmitters
programmed, the system will keep only the last 4 transmitters.
PROGRAMMING THE REMOTE TRANSMITTER
programmed, the system will keep only the last 4 transmitters.
PROGRAMMING THE REMOTE TRANSMITTER
Enter:
1. Turn the Ignition ‘switch ‘OFF/ON’ 3 TIMES and stay in ON
position. Within 15 seconds.
2. Push the Valet switch 2 times. (Holding in on the 2nd push) until you hear a long chirp. The
transmitter is ready to program.
Program:
position. Within 15 seconds.
2. Push the Valet switch 2 times. (Holding in on the 2nd push) until you hear a long chirp. The
transmitter is ready to program.
Program:
1. Press any button on
the transmitter until the siren responds with a confirming chirp the first
transmitter is now programmed.
2. Press button on the second transmitter until the siren responds with a confirming chirp, the
second transmitter is now programmed.
3. Apply the same procedure to program 3rd and 4th.
Exit: Turn Ignition to ‘OFF’ position, or leave it for 15 seconds. A 3 long chirps & 3 parking light
flashes to confirm exit.