ZyXEL Communications Corporation EMG1302R10A Manual Do Utilizador
Chapter 7 WAN
EMG1302-R10A User’s Guide
71
7.4.2 Bridge Encapsulation
This screen displays when you select Bridge encapsulation.
Figure 32
Internet Connection: Bridge Encapsulation
The following table describes the labels in this screen.
Passthrough
PPTP Passthrough
L2TP Passthrough
IPSec Passthrough
Apply
Click Apply to save your changes back to the EMG1302-R10A.
Cancel
Click Cancel to exit this screen without saving.
Table 15
Internet Connection: IP over Ethernet Encapsulation (continued)
LABEL
DESCRIPTION
Table 16
Internet Connection: Bridge Encapsulation
LABEL
DESCRIPTION
ISP Parameters for Internet Access
Encapsulation
Select Bridge when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP’s DHCP server directly. If
you select Bridge, you cannot use routing functions, such as DHCP server.
connected computers to get individual IP address from ISP’s DHCP server directly. If
you select Bridge, you cannot use routing functions, such as DHCP server.
The function is currently available for the IPv4 protocol.
Enable VID
VID (1~4094)
Enter a VLAN identifier between 1 to 4094 (the 802.1Q tag specifies only a priority and
is referred to as a priority tag). In bridge mode, VID 1 (the default VLAN ID) is reserved
for a management VLAN.
is referred to as a priority tag). In bridge mode, VID 1 (the default VLAN ID) is reserved
for a management VLAN.
Ignore WAN Vlan ID
when tag frame
reveive from LAN
site
when tag frame
reveive from LAN
site
Apply
Click Apply to save your changes back to the EMG1302-R10A.
Cancel
Click Cancel to exit this screen without saving.