ZyXEL Communications Corporation PRESTIGE310S Manual Do Utilizador
Prestige 310 Broadband Sharing Gateway
Transferring Files
10-4
Figure 10-4
Telnet into Menu 24.5
For details about backup using TFTP please refer to the section on TFTP File Transfer.
10.3 Restore Configuration
Menu 24.6 -- System Maintenance - Restore Configuration allows you to restore the configuration via the
console port. Note that this function erases the current configuration before restoring to the previous back up
configuration; please do not attempt to restore unless you have the a backup configuration stored on disk.
FTP and TFTP are the preferred methods for restoring your current workstation configuration to your
Prestige since FTP and TFTP are faster. Please note that the system reboots automatically after the file
transfer is complete.
console port. Note that this function erases the current configuration before restoring to the previous back up
configuration; please do not attempt to restore unless you have the a backup configuration stored on disk.
FTP and TFTP are the preferred methods for restoring your current workstation configuration to your
Prestige since FTP and TFTP are faster. Please note that the system reboots automatically after the file
transfer is complete.
Figure 10-5
Menu 24.6 - System Maintenance - Restore Configuration (via console port)
Step 1.
Go to menu 24.6.
Step 2.
Press “Y” to indicate that you want to continue. Follow the procedure as shown previously for the
HyperTerminal program. The procedure for other serial communications programs should be
similar.
HyperTerminal program. The procedure for other serial communications programs should be
similar.
Step 3.
Click “Transfer” in the HyperTerminal menu bar, then “Send File” from the drop-down menu.
Step 4.
Enter where the rom configuration file is on your computer, and make sure you choose the X-
Modem Protocol. Then press “Send”.
Modem Protocol. Then press “Send”.
Menu 24.6 -- System Maintenance - Restore Configuration
Ready to restore Configuration via Xmodem.
Do you want to continue (y/n):
Do you want to continue (y/n):
Menu 24.5 -- System Maintenance - Backup Configuration
To transfer the configuration file to your workstation, follow the procedure
below:
below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your router. Then type "root" and
SMT password as requested.
3. Locate the 'rom-0' file.
4. Type 'get rom-0' to back up the current router configuration to
your workstation.
2. Type "open" and the IP address of your router. Then type "root" and
SMT password as requested.
3. Locate the 'rom-0' file.
4. Type 'get rom-0' to back up the current router configuration to
your workstation.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on backup using TFTP (note that you must remain
in this menu to back up using TFTP), please see your router manual.
client program. For details on backup using TFTP (note that you must remain
in this menu to back up using TFTP), please see your router manual.
Press ENTER to Exit: