Hunter Fan Company TX44 Manual Do Utilizador
M3561-01 • 12/04/14 • © Hunter Fan Company
3
Ceiling
Plate
Receiver
Canopy
Receiver
Canopy
Ceiling
Bracket
Receiver
Fan Body
Cable Tie
Receiver
Canopy
Choose the hanging system that most closely
resembles the one used by your fan and place the
receiver as shown.
resembles the one used by your fan and place the
receiver as shown.
4
Note: If your canopy is crowded with excess wire, you may wish to cut
the excess fan wires. Leave a minimum of 8 inches remaining. Strip the
fan lead wires 1/2 inch. Place remaining excess wire into the ceiling
electrical box. The bracket and fan must remain properly grounded.
the excess fan wires. Leave a minimum of 8 inches remaining. Strip the
fan lead wires 1/2 inch. Place remaining excess wire into the ceiling
electrical box. The bracket and fan must remain properly grounded.
If the fan is installed on an angled ceiling and you need assistance with
installation, please call 1-888-830-1326.
installation, please call 1-888-830-1326.
For low profile fans, secure the receiver
to the ceiling bracket with a cable tie.
to the ceiling bracket with a cable tie.
installation (continued)
WARNING: This receiver cannot be installed in conjunction with any other receiver
or hard-wired wall control. Doing so will void your warranty.
or hard-wired wall control. Doing so will void your warranty.
Hanging System 1
Hanging System 2
Hanging System 3
Hanging System 4