Davis Instruments DWW6357 Manual Do Utilizador
Preparing the ISS for Installation
5
Installing the Debris Screen
The Vantage Vue ISS rain collector debris screen captures foreign matter or other
debris that may otherwise clog your rain collector and adversely affect the accuracy
of your rainfall measurements.
debris that may otherwise clog your rain collector and adversely affect the accuracy
of your rainfall measurements.
To install your debris screen, follow
these steps.
these steps.
1. Locate the small black plastic ISS
debris screen in your hardware
package.
package.
The debris screen has four small
tabs that hold it in place in the base
of the rain collector.
tabs that hold it in place in the base
of the rain collector.
2. Holding the ISS assembly with one
hand, and holding the debris screen
by the tab, press the screen into the
opening at the bottom of the rain
collector until you feel and hear the
tabs snap into the opening.
by the tab, press the screen into the
opening at the bottom of the rain
collector until you feel and hear the
tabs snap into the opening.
The screen will now be held
securely in the rain collector.
securely in the rain collector.
Installing the Rain Collector Tipping Spoon Assembly
To install the Tipping Spoon
Assembly, follow these steps:
Assembly, follow these steps:
1. Locate the Tipping Spoon
Assembly slot on the underside
of the ISS Base, as shown in the
drawing below.
of the ISS Base, as shown in the
drawing below.
2. Insert the wider end of the Tip-
ping Spoon Assembly into the
slot first, sliding it under the lip
of the slot.
slot first, sliding it under the lip
of the slot.
3. Tighten the thumbscrew
securely.
Debris
Screen
Screen
Rain
Collector
Collector
Tipping Spoon
Module