Xmark Corporation IMF Manual Do Utilizador

• MyCall

®

 Communicator

™

 tag (p/n 806A5601)—includes bat-

tery (installed).

•  MyCall Communicator tag fasteners. One of the following is 

required:

•  Neck chain or cord to wear around the neck.

•  Strap clips to clip Communicator tags to clothing.

•  Emergency Release Clip Set (p/n 805A3001) to fasten Com-

municator tags with a breakaway Panic alarm feature. Set 
includes 12 Release Clips (12 Alarm Clips and 12 Alarm 
Keys).

•   Wear the Communicator tag in full view.
 

The tag must remain visible in order to receive Beacon location 
transmissions. Do not cover the front of the tag when wearing 
it, or place it in a shirt or pants pocket.

•   Point the bulge outward to maximize the reception of Beacon 

location marker transmissions.

•  Do not place the Communicator tag where it could be bumped 

or damaged.

•  If using the Emergency Release Clip, ensure the breakaway chain 

or cords do not break before pulling the Alarm Key out of the 
Alarm Clip.

•  Do not mix FindIt

®

 tags with MyCall Communicator tags.

 

FindIt tags are designed specifi cally for the FindIt asset locating 
application. MyCall Communicator tags are designed specifi cally 
for the MyCall emergency response application. 

To call for help at any time, simply press the top or bottom button 
on the Communicator tag. As an option, the tag can be confi gured 
to emit a series of short beeps each time it is pressed.

Communicator tags can be worn in three different ways: around 
the neck like a pendant, clipped to a person’s clothes, or fastened 
securely to a person’s clothes to cause a Panic alarm automatically 
if pulled off.

  Turn the Communicator tag on.

 

The MyCall Communicator tag ships from the factory in a 
“sleep” mode to minimize battery consumption. Press either 
Communicator tag button to turn the Communicator tag on. 
The Communicator tag emits a short beep.

  Test the Communicator tag.

 

Before installing the Communicator tag, check that it is operating 
properly. Turn on Tag Diagnostics in the Xmark

®

 software, and 

then initiate a Panic alarm. Check the Xmark software to make 
sure that the alarm message has been received.

  Fasten the Communicator tag.

 

Installation differs depending upon the fastener used.

  Fastened to a neck chain or cord

 

Slip the neck chain or cord through the loop located on the 
top of the Communicator tag. Use a standard or breakaway 
chain or cord, as required.

© 2005 Xmark, a division of Instantel Inc. All Rights Reserved.  Xmark, the Xmark logo, MyCall 
and FindIt are registered trademarks of Instantel Inc. in North America. Communicator is a trademark 
of Instantel Inc. All other company and product names may be trademarks of their respective 
companies. Printed in Canada. June 2005. 806U5401 Rev 01.

808 Commerce Park Drive, Ogdensburg, NY  13669 USA   or 
309 Legget Drive, Ottawa, ON  K2K 3A3, Canada 

Telephone:  1-866-55-XMARK  International: +1 613-592-6997   Facsimile:  1-613-592-4296 
E-mail: sales@xmarksystems.com   Web Site: www.xmarksystems.com 

Certifi ed to the ISO 9001 Quality Standard