Hobbico Inc D2 Manual Do Utilizador

Plug charger into USB port or AC adapter (DIDP1125 not included) 
as shown and connect the battery. The red LED will flash slowly 
while the battery is charging. The LED will be steady when the 
battery is fully charged.

•  NEVER leave the battery unattended while charging.
•  DO NOT allow the USB port to power down while the charger 

is connected to the battery.

•  ALWAYS unplug the charger from the USB port and the 

battery when charging is complete.

•  The battery connector will only fit in one way.

Your KODO FPV comes with a Power-On Fail-Safe. This ensures that 

the motors will not start until the KODO has detected the controller.

1.  Turn on the controller with the throttle 

at its lowest position.

2.  Connect the battery to the KODO 

FPV and place it on a level surface. 
Listen for two beeps. The red LED at 
the back of the quadcopter will start 
fl ashing slowly.

3.  Move the throttle to its highest position. Listen for a beep.

4.  Move the throttle back to its lowest position. Listen for three 

beeps.

The KODO FPV’s motors are now armed and the quad is ready to 

fl y. The red LED on the KODO FPV will become steady.

BEFORE FLYING !

•  Do not mix old and new batteries.
•  Do not mix alkaline, standard, or 

rechargeable batteries.

Push down on the left stick to 

change the sensitivity

of the controls.

Lowest (Default)

Moderate

Maximum

Remove the screw on 
the battery compartment 
cover. Take the cover off 
and insert 4 AAA batteries. 
Replace cover, securing 
with the screw.

Video 

Button

Elevator 

Trim

Throttle/Rudder 

Stick

Rudder 

Trim

ON/OFF

Aileron 

Trim

Aileron/Elevator 

Stick

Throttle 

Trim

Phone Holder

Picture 

Button

KODO

™

 Drone

Controller

FPV Headset

Screwdriver

USB 
Charger

Spare Blades
(2 black, 2 red)

Flight Battery

4 AAA Batteries