CalAmp PC-UC-2 Manual Do Utilizador
«ProductName»
User Manual
7M303-1 Rev A2
Page 10
3 Two-way Radio Operation
The
Peoplefinder II
has a built-in radio transceiver enabling it to communicate with other two-way radios and to
receive over-the-air commands to generate pages.
To remotely control the
Peoplefinder II
with a two-way radio, the two-way radio must be equipped with a DTMF
encoder. All commands sent to the
Peoplefinder II
are entered via the DTMF keypad, and in most cases, the
commands are similar to the ones used locally on the
Peoplefinder II
's built-in keypad. During two-way radio
operations, the
Peoplefinder II
will not transmit pages. Any pages entered by the front panel, external keyboard or
computer ports will be queued and sent later, when the radio is idle.
3.1 Sending Pages from the Two-Way Radio
This section describes how to send a page with the
Peoplefinder II
using a DTMF keypad-equipped two-way radio.
The
Peoplefinder II
and the two-way radio must have previously been configured to communicate on the same
channel, and utilize the same CTCSS tones.
To send a page to a pager from the two-way radio, you must:
1. Send
* 9
to alert the
Peoplefinder II
that you intend to send a page.
2. If desired, optionally listen to the receiver for the "Enter Pager Number" prompt, which is a sequence of
three beeps. A series of alternating high and low beeps indicates an error in the command sequence or a
timeout occurred. If voice prompts have been enabled, then a voice message will be heard instead of the
beeps.
timeout occurred. If voice prompts have been enabled, then a voice message will be heard instead of the
beeps.
3. Enter the digits of the pager number you wish to page. If the pager's number is less than three digits in
length, then press the
*
key to terminate the pager's number. Note that the
*
key is not used to terminate
three digit pager numbers.
4. If desired, optionally listen to the receiver for a low / high beep sequence, which signifies that the pager
number was accepted. A series of alternating high and low beeps indicates an error in the pager number or
a timeout occurred. If voice prompts have been enabled, then a voice message will be heard instead of the
beeps.
a timeout occurred. If voice prompts have been enabled, then a voice message will be heard instead of the
beeps.
5. Enter the numeric digits you wish to send to the pager. Do not enter any digits if you only wish to "beep"
the pager. Note that the following DTMF keys have special meanings:
DTMF Key
Pager Character
Comments
*
-
Hyphen character
#
{none}
Send the page
A
Space character
B
]
Right bracket
C
[
Left bracket
D
U
Urgency indicator
6. Press the
#
key to send the page.
To send a new message to the same pager again, you may:
1. Type
* 0
to alert the
Peoplefinder II
that you intend to send a page to the same pager number as before.
2. Continue from step 4 of the instructions above to input the new message to be sent.