Indyme Solutions Inc CB526 Manual Do Utilizador
Technical Document
430668-00
Rev. E
Indyme Solutions, Inc. 8295 Aero Place San Diego, CA 92123 USA
+1.858.268.0717 +1.800.829.6141Page 1 of 2
CB526 Pocket Director Call Box
Programming the CB526:
If at any point during the programming sequence 30 seconds expire without a button being pressed, the address
programming mode will be exited and the previously programmed address will continue to be used. The
assurance LED will flash 5 times to indicate that mode programming has been exited.
1. Press and hold button 2 for 5 seconds. The assurance LED will flash once.
2. Press and hold button 1 for 5 seconds. The assurance LED will flash twice.
3. Press and hold button 2 for 5 seconds. The assurance LED will flash three times.
4. Press button 1 once.
5. Press button 2 once, the assurance LED will flash once.
If at any point during the programming sequence 30 seconds expire without a button being pressed, the address
programming mode will be exited and the previously programmed address will continue to be used. The
assurance LED will flash 5 times to indicate that mode programming has been exited.
1. Press and hold button 2 for 5 seconds. The assurance LED will flash once.
2. Press and hold button 1 for 5 seconds. The assurance LED will flash twice.
3. Press and hold button 2 for 5 seconds. The assurance LED will flash three times.
4. Press button 1 once.
5. Press button 2 once, the assurance LED will flash once.
You are now in Address Programming Mode.
6. To program the hundreds value, press button one 1-9 times.
7. Press button two, one time to save the hundreds value.
8. To program the tens value, press button one 1-9 times.
9. Press button two, one time to save the tens value.
10. To program the ones value, press button one 1-9 times.
11. Press button two, one time to save the ones value.
7. Press button two, one time to save the hundreds value.
8. To program the tens value, press button one 1-9 times.
9. Press button two, one time to save the tens value.
10. To program the ones value, press button one 1-9 times.
11. Press button two, one time to save the ones value.
The assurance LED will now flash back the address that was programmed.
NOTE:
To program the number zero (“0”) do not press button 1, instead, press 2.
During the flash back sequence, the LED indicates a zero by staying on longer.
The CB526 is a mini director call box designed for pocket or
clip-on use. The 4-membrane switch assembly is
designed without a reset button and is intended to be carried
by store employees desiring to trigger messages from various
locations within the store.
The CB526 call box has a single assurance LED, it will flash for
¼-sec when a button is pressed.