Indyme Solutions Inc TYPEA2 Manual Do Utilizador
Technical Document
430715-03
Rev. G
Indyme Solutions, Inc.
8295 Aero Place San Diego, CA 92123 USA +1.858.268.0717 +1.800.829.6141Page
1 of 5
CB911 Wireless Director Help button
Programming and Installation Instructions
Overview
The CB911 is a member of the Global Solutions Family. Indyme GSF products operate in the
800MHz
800MHz
ʹ 900MHz frequency spectrum. The CB911 is a 1-button, GSF, Director Help button
designed for use at POS, Customer Service or cash register locations. GSF Help buttons are
designed to communicate with a GSF Access Point. GSF products are not compatible with
legacy devices
designed to communicate with a GSF Access Point. GSF products are not compatible with
legacy devices
Programming Parameters
GSF products MUST be properly programmed to establish communication. Programming
parameters MUST match your configuration. The default settings are for testing purposes only
and should not be used. Failure to properly program your help button and access point will
prevent your devices from working.
GSF Help buttons have four primary programming parameters; Frequency Plan, Netcode,
Address and Operating Mode. These MUST be programmed in the correct order to establish
communication and ensure proper operation. Identify the parameters for your configuration
before you begin programming.
Using the programming instructions below set the following parameters in order.
parameters MUST match your configuration. The default settings are for testing purposes only
and should not be used. Failure to properly program your help button and access point will
prevent your devices from working.
GSF Help buttons have four primary programming parameters; Frequency Plan, Netcode,
Address and Operating Mode. These MUST be programmed in the correct order to establish
communication and ensure proper operation. Identify the parameters for your configuration
before you begin programming.
Using the programming instructions below set the following parameters in order.
Frequency Plan ʹ defines the frequency for your GSF devices.
Netcode ʹ unique identification code for the installation environment.
Address ʹ alarm number associated with a control unit alarm event.
Operating Mode ʹ defines how the help button will respond when activated.
Programming a help button requires a series of button presses. The specific buttons vary by help button type. On
the CB911, SET is
the CB911, SET is
ƚŚĞ͞PRESS HERE͟ďƵƚƚŽŶand RESET is a small circle to the right of the Indyme name at the
bottom of the help button. The assurance LED is red and is located next to the SET button. This LED will flash
during programming to indicate your progress.
during programming to indicate your progress.
Frequency Plan
*FP03 USA/Australia -918.100MHz
Netcode *00000001
Address *0001
Operating Mode
*1
* Default parameters are for testing purposes only.
CB911
LED
RESET