Pantech J-TOUCH Manual Do Utilizador
16
17
02
03
04
05
06
07
03
04
05
06
07
01
CHARGING YOUR BATTERY
1. Connect the USB data cable into the cableless wall
adapter.
2. Plug the USB data cable into the phone’s Charging/
Data Jack (making sure to align the connector as it
appears in the following image) and the wall adapter
end into an electrical outlet.
If the battery connector is not properly aligned, damage
could occur to the charging connector and the phone may
not charge.
3. To remove the Wall Charger, pull the charger from the device.
• When you charge the battery with the handset powered
off you will see a charging status screen. After the
charging has completed, the Charge Complete message
appears. You cannot operate the phone until it is powered
on. To turn your phone on, press and hold the Power Key
P
P
until your display turns on.
• The battery is not fully charged at the time of purchase.
Fully charge the battery before use.
• It is more efficient to charge the battery with the handset powered off.
• Battery operating time gradually decreases over time.
• If the battery fails to perform normally, you may need to replace the battery.
BATTERY HANDLING INFORMATION
DO’S
• Only use the battery and charger approved for use with the J-TOUCH
TM
.
• Only use the battery for its original purpose.
• Try to keep batteries in a temperature between 41°F (5°C) and 95°F (35°C). If the battery is stored in
temperatures above or below the recommended range, give it time to warm up or cool down before using.
• Store the discharged battery in a cool, dark, and dry place.
• Purchase a new battery when its operating time gradually decreases after fully charging.
• Properly dispose of the battery according to local laws.
DON’TS
• Don’t attempt to disassemble the battery – it is a sealed unit with no serviceable parts.
• Don’t accidentally short circuit the battery by carrying it in your pocket or purse with other metallic objects
such as coins, clips and pens. This may critically damage the battery.
• Don’t leave the battery in extremely hot or cold temperatures. Otherwise, it could significantly reduce the
capacity and lifetime of the battery.
• Don’t dispose of the battery by placing into a fire.
REMOVING THE MICROSD CARD
This device comes with a 1GB pre-installed microSD Card.
1. Open the microSD Card cover, and use your thumb to press and release the
microSD Card.
2. Press the memory card inward, gently, until it pops out. Remove the microSD
Card.
3. Close the microSD Card cover.
To prevent possible damages, please keep the microSD Card cover closed at all times
regardless of whether the microSD Card is inserted or not.
•BEFORE USING
Correct
Incorrect
Correct
Incorrect