Silverstone ST85ZF SST-ST85ZF Manual Do Utilizador
Códigos do produto
SST-ST85ZF
Description:
Electrical Specification
SilverStone Technology Co., Ltd.
Subject:
SilverStone Technology
Model: ST85ZF
Switching Power Supply
Document No.:
ES-850-ZEUS-01
File Name: ST85ZF.doc Page : 8
3.8 Overshoot at Turn-on /Turn-off
Any output overshoot at turn on shall be less than 10% of the nominal output value. Any overshoot shall
recover to within regulation in less than 10ms.
recover to within regulation in less than 10ms.
3.9 Efficiency
The minimum power supply system efficiency shall be
≥ 80% with maximum efficiency up to 87%, measured
at nominal input voltage 115 V or 230 V and full loading.
3.10 +5VSB (Standby)
The +5VSB output is always on (+5V Standby) when AC power is applied and power switch is turned
on. The
+5VSB line is capable of delivering at a maximum of 3.0A for PC board circuit to operate.
4. Protection
Protection circuits inside the power supply shall cause only the power supply’s main outputs to shutdown. If
the power supply latches off due to a protection circuit tripping, either a AC cycle OFF for 15 sec, or PSON#
cycle HIGH for 1 sec must be able to restart the power supply.
the power supply latches off due to a protection circuit tripping, either a AC cycle OFF for 15 sec, or PSON#
cycle HIGH for 1 sec must be able to restart the power supply.
4.1 Over Current Protection
This power supply shall have current limit to prevent the +5V, +3.3V, and +12V outputs from exceeding the
values shown in table 14. The current limit shall not trip under maximum continuous load or peak loading as
described in Table 5. The power supply shall latch off if the current exceeds the limit. The latch shall be
cleared by toggling the PSON# signal or by cycling the AC power. The power supply shall not be damaged
from repeated power cycling in this condition. The –12V and +5VSB outputs shall be shorted circuit protected
so that no damage can occur to the power supply.
values shown in table 14. The current limit shall not trip under maximum continuous load or peak loading as
described in Table 5. The power supply shall latch off if the current exceeds the limit. The latch shall be
cleared by toggling the PSON# signal or by cycling the AC power. The power supply shall not be damaged
from repeated power cycling in this condition. The –12V and +5VSB outputs shall be shorted circuit protected
so that no damage can occur to the power supply.
Voltage
Minimum
Maximum
Shutdown Mode
+5V 110% 150%
Latch
Off
+3.3V 110% 150%
Latch
Off
+12V 110% 150%
Latch
Off
Table 14 –Over Current protection
4.2 Over Voltage Protection
Power supply shall shut down in latch off mode when the output voltage exceeds the over voltage limit.
Voltage
Minimum
Maximum
Shutdown Mode
+5V +5.7V
+6.5V
Latch
Off
+3.3V +3.9V
+4.5V
Latch
Off
+12V1,2,3,4,5 +13.3V
+14.5V
Latch
Off
-12V -13.3
-14.5
Latch
Off
5VSB 5.7
6.5
Latch
Off
Table 15 –Over Voltage protection