Itron Inc. FNCCU4 Manual Do Utilizador

Página de 58
DRAFT
10
CCU4 Collector Field Installation and Service Guide
TDC-0359-000b 04/02
RF Antenna Angle
Example: Aluminum Light Pole Wind Load
A G.E. Light Systems davit and pole support a maximum weight of 60 pounds and a maximum
EPA of 1.5, rated at 100 MPHI (Miles Per Hour Isotach). The existing light fixture weighs 35
pounds and has a .7 EPA.
The CCU4 collector (including mounting hardware) weighs 23 pounds
and has a .7 EPA.
The combined weight of the collector and the light fixture is 58 pounds. The
combined EPA of the collector and the light fixture is 1.4.
The following equation shows the calculations for this installation:
(35 lb) + (23 lb) = 58 lb
(.7) + (.7) = 1.4
Since the combined totals are less than the maximum weight (60 pounds) and the maximum EPA
(1.5) ratings of the davit, the installation is feasible.
RF Antenna Angle
Regardless of the specific attachment point, the collector antenna must be vertical (plumb),
extending downward, perpendicular to the horizon.
Measuring the Mounting Angle of a Pole or Davit
Two factors involved in achieving a plumb installation are the angles of the pole and the davit.
Using an Itron Protractor, you can measure the angles of the pole and davit, as described below.
To measure the mounting angle of a davit, place the Itron Protractor on top of the davit above
where the collector will be mounted. Verify the angle is no more than 15 degrees away from 0
degrees.
To measure the slant of a wood pole, place the Itron Protractor against the wood pole. Verify the
angle is no more than 15 degrees away from 90 degrees.
Figure 4:
Measuring the Mounting Angle of a Pole or Davit
If either angle is more than 15 degrees, adjust the angle of the collector when attaching it to the
hanging plate by varying the connection points of the bolts connecting the hanging plate to the
collector’s L-brackets.
75 90 75
15
0 15
Davit
Wood
Pole
Davit
Wood Pole
Itron Protractor