CALAMP WIRELESS NETWORKS INC. BDP3-AET Manual Do Utilizador

 
 

120 20191-001 

 Paragon-III  Technical Manual

 

 

General Check out (part2 of 2) 

Paragon-III units are set and characterized at the factory to optimize performances.  

It is not recommended to try readjusting units unless it is really required.  

Misadjusting unit may result in significant performance losses. 

performance degradation is noticed combined with out of tolerance items. 

°C 

Set the service monitor to generate on the selected receive frequency. Verify alternately for both receivers. 

The carrier should be modulated with a 1.0 kHz tone at deviation level specified below: 

8 

12 dB SINAD 

(Dataradio wide band 
measurement method: no 
audio filtering) 

Set deviation to  ±8 kHz.  

 

Better than  -108 dBm  

including cable loss 

(Typically -109 to -110 dBm)

 

- Backplane correspond-

ing to the receiver be-
ing verified: J1 (RX1) 
or J5 (RX2),  
Pin 6 (see Figure 13, 
page 15) 

-  Service monitor  (IFR) 

set to SINAD 

-  IFR IF filter set to MID 

position or 300 kHz 
wide filter. 

 

Refer to section 5.2.2 

9 

Receiver distortion  

(Dataradio wide band 
measurement method: no 
audio filtering)  
-  Set service monitor RF 

Gen output to –70 dBm 

-  Deviation level as per 

SINAD above. 

 

≤ 5.5 % 

(Typically < 3.5 %) 

- Backplane correspond-

ing to the receiver be-
ing verified:  
J1 (RX1) or J5 (RX2), 
Pin 6 (see Figure 13) 

-  Service monitor  (IFR) 

set to DISTORTION. 

- 

IFR IF filter set to MID 
position or 300 kHz 
wide filter

. 

Refer to section 5.2.2  

10 

RSSI 
Apply to each receiver 
input the following RF 
level  of   -110dBm  

2.0 VDC (+/- 0.3VDC) 

- Backplane correspond-

ing to the receiver be-
ing verified:  
J1 (RX1) or J5 (RX2), 
Pin 5 (see Figure 13) 

- DC Voltmeter 

measurement 

Refer to section 5.2.2.5 for 
all models. 
Refer to factory technical 
support only if RX data 
performance degradation is 
noticed combined with out 
of tolerance RSSI readings.