CALAMP WIRELESS NETWORKS INC. BDP3-AMP Manual Do Utilizador
120 20191-100a
Paragon-III User Manual
5
2. Installation
2.1 Overview
The cabinet and rack-mount housing the Paragon-III’s radio-modem and Power Amplifier is
generally installed in a sheltered facility. Occasionally located adjacent to the nerve center of the
user’s network, it is often located near tower sites or at remote locations where it operates unattended.
generally installed in a sheltered facility. Occasionally located adjacent to the nerve center of the
user’s network, it is often located near tower sites or at remote locations where it operates unattended.
Furnishings needed include power, cabling, and installation of antenna, landline or microwave mo-
dem, and host PC or portable computer. Details of these are outside the scope of this manual. This
manual covers the radio-modem assembly and the power amplifier.
dem, and host PC or portable computer. Details of these are outside the scope of this manual. This
manual covers the radio-modem assembly and the power amplifier.
2.2 Location
Be sure to place the Paragon-III in such a way that:
• The LEDs can be seen (as an aid in troubleshooting)
• Access to the antenna connector and to the back connectors is possible without removing the unit
• Sufficient air may flow around the unit to provide adequate cooling.
• The LEDs can be seen (as an aid in troubleshooting)
• Access to the antenna connector and to the back connectors is possible without removing the unit
• Sufficient air may flow around the unit to provide adequate cooling.
2.3 Front View
Model using Amplifier Technologies Inc power amplifier.
Figure 1 - Typical rack-mount multi-modules "Radio Assembly"
®
®
®
Exciter
Carrier
On
Line
Sensitivity
Supply
Microphone
®
Diversity
SDR Rx
SDR Rx
LOCK
RCVR
GATE
GATE
LEVEL
Volume
COM
2
Norm -Mon
®
®
Speaker Panel
programming
port
RX2
RX1
OFF
SPEAKER
SELECT SWITCH
Air Flow
Power Supply
Power Supply
PWR
1
1
2
®
PWR
TX
BSC
ETH 2
RX
USB
ETH 1
COM 2
COM 1
STATUS