CALAMP WIRELESS NETWORKS INC. BDP3-CRE700 Manual Do Utilizador
120 20194-102
Paragon3 – 700/800MHz User Manual
48
Table 5 - Checklist A (After installation)
CHECKLIST A (
Paragon3
)
Recommended Check out after Installation
Step
ACTION
EXPECTED RESULTS at
25
°C
MEASURE WITH
IF NOT?
Normal Power-up
Sequence
Sequence
BSC
PWR LED lights red for four second, turns amber for one second, and stays
green thereafter.
TX LED flashes green once about fifteen seconds after power-up then keeps
flashing in-tune to the cycle marker
RX LED remains OFF
STATUS LED remains OFF
ETH 1 LED – if connection present – lights green. Flashes amber with activity
ETH 2 LED – If connection present – lights green. Flashes amber with activity
STATUS LED remains OFF
ETH 1 LED – if connection present – lights green. Flashes amber with activity
ETH 2 LED – If connection present – lights green. Flashes amber with activity
Receivers
GATE LED must remain steady red
SUPPLY LED must remain steady green
SUPPLY LED must remain steady green
1
Transmitter
SUPPLY LED must remain steady green
ON LED lights red for one second, turns OFF for 10 seconds, and stays red
thereafter
ON LED lights red for one second, turns OFF for 10 seconds, and stays red
thereafter
For steps below, on the Radio Î Set Up Web page, press the “test” button to enable Test Tone function
2
Power Amplifier Output Power
From the Maintenance unit WEB
“Test Tone” page,
“Test Tone” page,
Select Unmodulated
and press “Execute”
70 watts nominal
(settable down to 35W in fac-
tory)
Tolerance: +15% -20%
Service monitor set to
read power
or
100W in-line wattme-
ter installed as close
as possible to the unit
antenna connector.
read power
or
100W in-line wattme-
ter installed as close
as possible to the unit
antenna connector.
Check for bad connec-
tions, damaged coax
cable, etc.
tions, damaged coax
cable, etc.
3
Transmitter Reflected Power
Select Unmodulated - Execute
< 5% of forward power or
as specified by System
Engineering.
as specified by System
Engineering.
10W in-line wattmeter
Check for bad connec-
tions, damaged coax
cable, etc.
tions, damaged coax
cable, etc.