CALAMP WIRELESS NETWORKS INC. BDP4-EXT8 Manual Do Utilizador
120 20195-100 Preliminary
Paragon4 – UHF, 700, & 800MHz User Manual
8
Torque Settings:
The manufacturer recommends torque setting all power supply terminal screws to a minimum of:
• 1.5 Nm (or 13.28 Inlb or to 1.107 ftlb)
The manufacturer recommends torque setting all power supply terminal screws to a minimum of:
• 1.5 Nm (or 13.28 Inlb or to 1.107 ftlb)
Note: Dataradio uses a Sturtuvan Richmond 29-pieces adjustable torque screwdriver model
CAL36/4K.
After tightening, pull on the cable to check the cable is secured tightly into the screw terminal.
2.4.1.2 Power Indications
Both red-colored translucent power switches located on the front of the power supply modules illu-
minate when AC power is available. Toggle both to ON to distribute power to the Radio Assembly
and to the Power Amplifier. The LED immediately below the switches light green indicating normal
DC power operation.
Both red-colored translucent power switches located on the front of the power supply modules illu-
minate when AC power is available. Toggle both to ON to distribute power to the Radio Assembly
and to the Power Amplifier. The LED immediately below the switches light green indicating normal
DC power operation.
2.4.2
Backplane Fuses
Blade fuses (Maxi-Fuse) are used on the Radio assembly backplane:
Dimensions – Inch (mm)
Fuse Type
A
B
C
Maxi-Fuse
1.15 (29.21)
1.35 (34.29)
.35 (8.89)
Fuse #
F1
F2
F3
Values
10A
15A*
15A*
*
Always replace the two 15A fuses as a pair.
Figure 4 - Maxi-Fuse