Crestron Electronics Inc CWD1012 Manual Do Utilizador
Two-Way RF Transceiver Module
Crestron MNET-CWD1012
2
• Two-Way RF Transceiver Module: MNET-CWD1012
Hardware Guide - DOC. 6137
Specifications
The table below is a summary of specifications for the MNET-CWD1012.
Specifications of the MNET-CWD1012
SPECIFICATION
DETAILS
Power Requirements
0.75 Watts (5VDC @ 0.150A)
Operating Frequency
2400 MHz to 2483.6 MHz (802.15.4 compliant)
Operating Ranges¹
Minimum Distance
Maximum Distance Indoors
(without repeater device)
(without repeater device)
3 ft
100 ft
Available Channels
16 (numbered 11 through 26 per 802.15.4)
RF Output Power
10 mW
Serial Communications
TTL Level, 38400 Baud, 8 data bits, 1 stop
bit, no parity, software flow control
Antenna (included)
Type
Antenna Connector
V.S.W.R
Gain
Dipole Antenna
SMA Non-Standard Female Connector with
¼-36 UNS2B Screw
1.9 : 1
2.0 dBi
±
0.5
Dimensions
Width: 1.50 in (3.81 cm)
Height: 2.50 in (6.35 cm)
Depth: 0.36 in (0.91 cm)
1.
The location of the module and the orientation of the antenna are important factors in the RF
performance. With the unit located outside of any metal enclosures, the antenna is adjusted to
achieve the best range. The range is dependent on its placement and the building in which it is used.
The construction of the building, obstructions, and RF interference from other devices are factors
determining the effective range of the unit. To prevent unit-to-unit RF interference, multiple
modules operating at the same frequencies should not be installed within 3-5 feet of each other.
performance. With the unit located outside of any metal enclosures, the antenna is adjusted to
achieve the best range. The range is dependent on its placement and the building in which it is used.
The construction of the building, obstructions, and RF interference from other devices are factors
determining the effective range of the unit. To prevent unit-to-unit RF interference, multiple
modules operating at the same frequencies should not be installed within 3-5 feet of each other.
Physical Description
The module, shown below, consists of various components attached to a printed
circuit board. A SMA non-standard female antenna port is located at edge of the
circuit board for attaching the included dipole antenna while a 31-pin interface
connector is located on the underside of the circuit board.
circuit board. A SMA non-standard female antenna port is located at edge of the
circuit board for attaching the included dipole antenna while a 31-pin interface
connector is located on the underside of the circuit board.
Physical View of MNET-CWD1012