Digital Security Controls Ltd. 06PC5132 Manual Do Utilizador

11

Press any function key at several different locations.

 Press and hold the test mode tab for 5 seconds. Release the test

mode tab. The keypad will display the test result.

Read the test results at the keypad:

Good

Light 1 On Steady

“Good”

1 Beep/Squawk

Bad

Light 3 On Steady

“Bad”

3 Beeps/Squawks

Activate the device until you get 3 ‘good’ results in a row.
You may mount the WLS devices where results were good.

Devices indicating a bad result must be moved to another location. You may
only have to move the device a few inches to correct a bad result.

 

 Do not mount any device where a “bad” test result was indicated.

7. Go to the next device to be tested and activate it until the test result is

displayed/sounded.

NOTE: Wait until the placement test of one device is shown/sounded before begin-
ning to test the next device.

Continue to test the devices until both the RF5132-433 and the devices are in good
locations. If several wireless devices produce ‘bad’ test results, you may need to
move the RF5132-433 to a better location. (See section 2.2 for tips on finding a
location for the RF5132-433.)

8. To exit the placement test and return to installer programming, press [#] twice.

1. Temporarily place the WLS904P-433, WLS906-433 or WLS925L-433 where

you want to mount it.

2. At a system keypad, enter [*][8][Installer Code].
3. Enter programming section [904].
4

Enter the 2-digit zone number for the device to be tested.

5. Activate the device being tested until a result is displayed on the keypad or

sounded by the keypad or bell. (Same as step 5 in the Global Placement Test
section, previous page.)

6. To test another device, press [#] once, then repeat steps 4 - 5. Continue to

test the devices until both the RF5132-433 and the devices are in good
locations.
If several wireless devices produce ‘bad’ test results, you may need to move
the RF5132-433 to a better location. (See section 2.2 for tips on finding a
location for the RF5132-433.)

7. To exit the placement test and installer programming, press [#] twice.

You cannot use the individual device test described above to test WLS909-433/
WLS919-433 wireless keys. To ensure that the RF5132-433 receiver is receiving
transmissions from these devices, use the function keys on the WLS909-433/
WLS919-433 at several different points in the installation.