ADC Telecommunications Inc. DLC0802A Manual Do Utilizador
ADCP-75-150 • Preliminary Issue A • March 2003 • Section 4: Operation
Page 4-12
©
©
2003, ADC Telecommunications, Inc.
Figure 4-8. HOST RF Display
Figure 4-9. Host Fwd Att Pop-Up Screen
2.6
Determine Output Signal Level at STM Antenna Port
The
RF output signal level should be measured at the STM ANTENNA port to verify that
maximum
composite signal level is at the required level. Use the following procedure to
determine
the power level:
1. Verify
that RF ON/OFF switch on the LPA in the OFF position.
2. Disconnect
the antenna cable from the STM ANTENNA port.
3. Connect
a spectrum analyzer or RF power meter to the STM ANTENNA port. (Check the
input
rating of the test equipment. Insert a 30 dB 100 W attenuator if necessary.)
Right-click here
to open Host Fwd
Att pop-up screen
to open Host Fwd
Att pop-up screen
FCC ID: F8I-DLC0802A User Manual - Part 6