ADC Telecommunications Inc. DLCSMR2A Manual Do Utilizador
ADCP-75-159 • Issue 1 • August 2003 • Section 4: Operation
Page 4-12
© 2003, ADC Telecommunications, Inc.
© 2003, ADC Telecommunications, Inc.
Figure 4-8. HOST RF Display
Figure 4-9. Host Fwd Att Pop-Up Screen
2.6
Determine Output Signal Level at STM Antenna Port
The RF output signal level should be measured at the STM ANTENNA port to verify that
maximum composite signal level is at the required level. Use the following procedure to
determine the power level:
maximum composite signal level is at the required level. Use the following procedure to
determine the power level:
1. Verify that RF ON/OFF switch on the LPA in the OFF position.
2. Disconnect the antenna cable from the STM ANTENNA port.
3. Connect a spectrum analyzer or RF power meter to the STM ANTENNA port. (Check the
input rating of the test equipment. Insert a 30 dB 100 W attenuator if necessary.)
Right-click here
to open Host Fwd
Att pop-up screen
to open Host Fwd
Att pop-up screen
FCC ID: F8I-DLCSMR2A User Manual - Part 6