ADC Telecommunications Inc. FWURHSMR2 Manual Do Utilizador

 
 
 
 
 

Mailing Address: P.O. Box 1101, Minneapolis, Minnesota 55440-1101 

World Headquarters: Minneapolis, Minnesota  USA  +1.952.938.8080   www.adc.com

 

 
 

 
 

 
 

A 15-foot connectorized 3-wire cable is provided for the AC power connections. The connectorized end 
of the cable connects to the AC power port located on the bottom of the enclosure. The stub end of the 
cable must be routed to an external junction box (not provided) for permanent connection to the AC 
power system wiring.  The socket outlet shall be installed near the equipment and shall be easily 
accessible.  

 

 
The AC power source must supply 120 or 240 VAC, 50 or 60 Hz, single-phase power through a 
15 Amp circuit breaker. The AC power cable provides three wire leads for line, neutral, and 
ground connections. The power cable is rated for indoor or outdoor use and must not be placed 
within electrical conduit as this will impede the cooling of the cable during usage. The electrical 
junction box and any conduit, wire, and fittings required must be provided by the installer. 

  

 

 
Use the following procedure to install the AC power wiring: 

1. Locate the AC power cable that is provided separately with the enclosure. 
2. Route the power cable between the AC power port, located on the underside of the enclosure 
and the nearest AC power junction box as shown in 

Figure 14

. It may be necessary to install a 

new junction box if an existing junction box is not available.

 

 

 

                              

 

 

Figure 14. Typical AC Power Cable Routing