Buffalo 09101695-0 Manual Do Utilizador
17
16
Chapter 1 Product Overview
- 9 -
Bottom
16
Reset button
To reset all settings, hold down this button until the Buffalo LED turns red
(about 3 seconds). The power must be on for this to work.
(about 3 seconds). The power must be on for this to work.
17
Setup card slot
This is the slot where the AirStation setup card is stored. The initial
settings for the username, password, SSID, and encryption type are
provided on the card for logging into the configuration interface.
settings for the username, password, SSID, and encryption type are
provided on the card for logging into the configuration interface.
10
LAN Port
Connect your computer, hub, or other Ethernet devices to these ports.
This switching hub supports 10 Mbps,100 Mbps, and 1000 Mbps
connections.
This switching hub supports 10 Mbps,100 Mbps, and 1000 Mbps
connections.
11
Internet Port
10 Mbps, 100 Mbps, and 1000 Mbps connections are supported.
Note: In bridge/AP mode (router off), the Internet port becomes a
Note: In bridge/AP mode (router off), the Internet port becomes a
regular LAN port, for a total of 5 usable LAN ports.
12
LAN LED (Green)
On:
On:
An Ethernet device is connected.
Blinking:
An Ethernet device is communicating.
13
Internet LED (Green)
On:
On:
The Internet port is connected.
Blinking:
The Internet port is transmitting data.
14
Power button
This button turns the power on and off.
15
DC connector
Connect the included AC adapter here.