Everspring Industry Co Ltd AD130 Manual Do Utilizador

1 

 

This plug-in Lamp Module is designed to work with our Passive Infrared Detectors   
SP103 and Door/Window Detectors SM103, serving as a receiver. The AD130 
plug-in Lamp Module is a Z-Wave

TM

 enabled device and is fully compatible with 

any Z-Wave

TM

 enabled network. Z-Wave

TM

 enabled devices displaying the 

Z-Wave

TM

 logo can also be used with it regardless of the manufacturer, and ours 

can also be used in other manufacturer’s Z-Wave

TM

 enabled networks.    Inclusion 

of the Lamp module on other manufacturer’s Wireless Controller menu allows 
remote On/Off control and dimming of lamps connected.  

Each module is 

designed to act as a repeater.    Repeaters will re-transmit the RF signal to ensure 
that the signal is received by its intended destination by routing the signal around 
obstacles and radio dead spots. 

 

 

 
In the side of the casing, there is an On/Off/Dim knob which is used to carry out 
inclusion, exclusion or association. Put a Z-Wave

TM

 Wireless Controller into 

inclusion/exclusion mode, press the knob on the module to complete the 
inclusion/exclusion process. 
 
 
 
 
 
 
 
 

1.  Plug this Lamp module into a wall outlet near the lamp to be controlled. 
 
2.  Plug the lamp into the Lamp module.  Make sure the lamp to be controlled 

cannot exceed 200 watts. 

 
3.  Turn the knob or switch on the lamp to the ON position. 
 
4.  To manually turn ON the AD130 Lamp Module, press and release the On/Off 

knob. The red indicator LED will turn ON, and the lamp plugged into the AD130 

Lamp module will also turn ON. 

 
5.  To manually turn OFF the AD130 Lamp Module, simply press and release the 

On/Off knob. The red indicator LED will turn OFF and the lamp plugged into 
the AD130 Lamp Module will also turn OFF. 

 
6.  To manually dim the AD130 Lamp Module, press and hold the On/Off knob 

until the desired lighting level has been reached. 

 
7.  If Passive Infrared Detector SP103 or Door/Window Detector SM103 has been 

removed from the wall by triggering the tamper switch, the Detector (SP103 or 
SM103) will send an alarm command (ALARM_REPORT, Alarm Type == 
0x01, Alarm Level == 0x11) to the AD130 Lamp Module, of which red 
indicator LED and the lamp plugged into the AD130 Lamp module will flash for 
10 seconds simultaneously. 

 

Programming 
 

The On/Off/Dim knob allows the user 
- 

Turn on, off or dim the lamp attached 

- 

Include or exclude the module from the Z-Wave

TM

 system 

- 

Control other Z-Wave

TM

 enabled devices 

 
See the instructions for SP103 Passive Infrared Detector or SM103 Door/Window 
Detector. 
   

Troubleshooting 
                                   

The Module not working and 
LED off 

1.  The Module is not 

plugged into the 
electrical outlet 
properly 

2.  The Module is out of 

order 

1.  Check power connections 
2. Don’t open up the Module and 

send it for repair. 

The Module LED illuminating, 
but cannot control the ON/OFF
Switch of the lamp attached 

Check if the lamp plugged 
into the Module has 
burned out 

Replace a new lamp 

The Module LED illuminating, 
but the Detector cannot control
the Module 

1. Not carry out 

association 

2. Frequency interference

1. Carry out association 
2. Wait for a while to re-try