Everspring Industry Co Ltd SP101 Manual Do Utilizador
1
Simple Alarm System
Portable RF 2-tone Sounder
1
3-position slide switch
Power/volume/mode selection
4
Hanging Slot
7
Battery Compartment
2
Jack for AC adapter
5
Sticker
8
Battery Cover
3
Buzzer
6
Code Learning Button
The Portable RF 2-tone Sounder, a 2-in-1 wireless receiver, is designed to work
with the Magnetic Contact Detector (SM101), Wireless PIR Detector (SP101) and
Chime Remote Button (SR101), serving as an audible chime or alarm.
Before selecting a position for the Sounder the following points should be noted:
1. Do not fix the Sounder to metalwork or locate the unit within 1m of metalwork
(i.e. radiator, water pipes etc) as this could affect the radio range of the unit.
2. Do not locate the Sounder directly above a heat source, (e.g. fire, radiator,
boiler, etc)
3. Do not locate the Sounder where it is exposed to ventilators.
Loading the Battery
1. Open the battery cover. (FIGURE 1)
2. Insert 3 AA-size 1.5V batteries to the battery compartment, ensuring that correct
1. Open the battery cover. (FIGURE 1)
2. Insert 3 AA-size 1.5V batteries to the battery compartment, ensuring that correct
polarity is put.
3. Refit the battery cover.
FIGURE 1
Setting
1. The Sounder is able to memorize 10 set of individual codes.
2. Code learning
Note: For the best results, keep approx. 1 meter away from the transmitters
1. The Sounder is able to memorize 10 set of individual codes.
2. Code learning
Note: For the best results, keep approx. 1 meter away from the transmitters
when proceeding with the code learning. The minimum distance between the
receiver and transmitter for code learning is 15 cm.
receiver and transmitter for code learning is 15 cm.
a. Setting the chime code
Step 1: Set the 3-position slide switch to “LO”. (FIGURE 2a)
Step 2: Open the battery cover.
Step 1: Set the 3-position slide switch to “LO”. (FIGURE 2a)
Step 2: Open the battery cover.
Step 3: Using a ball-point pen, press and hold the code learning button for
more than 3 seconds. (FIGURE 2b & 2c)
Step 4: Keep holding the button. The Sounder will bleep per second.
After a long bleep being heard, it will enter code learning mode.
Step 5: Upon entering the code learning mode, release the button. The
After a long bleep being heard, it will enter code learning mode.
Step 5: Upon entering the code learning mode, release the button. The
Sounder is about to receive the code learning command within
30 seconds. During this 30 seconds period, the Sounder will react
with a long bleep as a confirmation if the code learning is successful.
Wait for at least 3 seconds to start operating.
30 seconds. During this 30 seconds period, the Sounder will react
with a long bleep as a confirmation if the code learning is successful.
Wait for at least 3 seconds to start operating.
Step 6: Upon entering the code learning mode, release the button. The
Sounder is about to receive the code learning command within 30
seconds. During this 30 seconds period, the Sounder will emit four
seconds. During this 30 seconds period, the Sounder will emit four