Se Jin Electron Inc SWK-4200RJ Manual Do Utilizador

 

2.  Using a paperclip or a small pin, hold down the “Connect” button inside a pinhole on 

the USB dongle until a RED LED lights up (hold down for about 2-3 seconds) [Figure 2]..     

 

[USB Dongle Connect Button shown below]   

 

 

 

  

 

 

[Figure 2] 

 

3. On the keyboard, press the “Connect” button inside. [Figure 1]. The keyboard will 

attempt to communicate with the dongle. When they are connected successfully, the 

red LED on the USB dongle will go out.    However, if the keyboard has been connected 

to the same dongle before, the red LED will stay on for 10-30 seconds before going out. 

This is when the dongle sustains the old connection setting and allows a new second 

keyboard to get connected simultaneously; however, both keyboards may not be 

operated at the same time.  The previous connection setting is stored inside the 

keyboard even if you remove the batteries. 

Cautions: Connecting procedure has to be completed in 30 seconds; otherwise you would 

have to start over from the beginning. 

 

 

1.  Using a paperclip or a small pin, hold down the “Connect” button inside a pinhole on 

the USB dongle for about two seconds.    A red LED should light up after this. 

2.  Press “Connect” button on the bottom of the mouse briefly.  The mouse will attempt 

to communicate with the dongle. When they are connected successfully, the red LED on 

the USB dongle will go out.  However, if the mouse has been connected to the same 

dongle before, the red LED will stay on for 10-30 seconds before going out. This is when 

the dongle sustains the old connection setting and allows a new second mouse to get 

connected simultaneously; however, both mice may not be operated at the same time.   

Previous connection setting is stored inside the mouse even if you remove the batteries. 

Cautions: Connecting procedure has to be completed in 30 seconds; otherwise you would