ViewSonic Corporation VS10407 Manual Do Utilizador
ViewSonic
3-in-1 Access Point
10
Step 1. Connect the Access point.
1. Make sure you have all the setup information from your Internet Service
Provider (ISP).
2. Make sure that all network hardware is turned off, including the Router,
computer(s), and cable or DSL modem.
3. Connect a standard Ethernet network cable to the Access Point.
Connect the other end of the Ethernet cable to a Switch or Router. The
Access Point will then be connected to your 10/100 Network.
Access Point will then be connected to your 10/100 Network.
4. Connect the AC power adapter from the power jack on the back of the
Access Point to an AC wall outlet as shown or to a power strip with surge
protection. The power LED on the front of the AP turns blue when there
is power.
protection. The power LED on the front of the AP turns blue when there
is power.
Power Jack
Back of AP
AC Power Adapter
AC Wall Outlet