ACCO Brands 33374-D Manual Do Utilizador

Your new Wireless Presenter with Laser Pointer offers you increased control 
for more effective presentations. Please read this short manual to learn 
valuable information about the proper use and installation of your new
Wireless Presenter with Laser Pointer. Register your new Wireless Presenter
with Laser Pointer online at www.register.kensington.com.

Range:

Up to 60 feet (18m)

Frequency:

2.4 GHz

Battery:

2 AAA batteries

System Requirement: PC running Windows XP®, 2000®; Macintosh® running

Mac® OS 10.2.8 or later; Available USB port.

N1368

A Division of ACCO Brands
333 Twin Dolphin Drive, Redwood Shores, CA 94065
Designed in California, U.S.A. by Kensington

Made in China
www.kensington.com

United States

1 800 535 4242

Note: The Wireless Presenter with Laser Pointer model number 33374 has been tested and
found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. 
If this equipment causes harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver 

is connected.

• Consult the dealer or an experienced radio/TV technician for help.
MODIFICATIONS: Modifications not expressly approved by Kensington may void the user’s
authority to operate the device under FCC regulations and must not be made.

The Wireless Presenter with Laser Pointer model number 33374 complies with Part 15 
of the FCC Rules and Industry Canada RSS-210. Operation is subject to two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. As defined in Section 2.909
of the FCC Rules, the responsible party for this device is Kensington Computer Products Group,
333 Twin Dolphin Drive, CA 94065, USA.
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la
classe B est conforme à la norme NMB-003 du Canada.

The use of the symbol indicates that this product may not be treated as household
waste. By ensuring this product is disposed of correctly, you will help prevent
potential negative consequences for the environment and human health, which 
could otherwise be caused by inappropriate waste handling of this product. For 

more detailed information about recycling of this product, please contact your local city 
office, your household waste disposal service or the shop where you purchased the product.

Kensington is a registered trademark of ACCO Brands. The Kensington Promise is a service mark of ACCO
Brands. Microsoft, Powerpoint, Windows and the Windows logo are trademarks or registered trademarks
of Microsoft Corporation in the United States and/or other countries. Apple, Macintosh, Mac and Keynote
are trademarks of Apple Computer, Inc. All other trademarks are the property of their respective owners.

©2006 Kensington Computer Products Group, a division of ACCO Brands. Any unauthorized copying,
duplicating, or other reproduction of the contents hereof is prohibited without written consent from
Kensington Computer Products Group. All rights reserved. 4/06

ACCO Canada Inc.
5 Precidio Court
Brampton 
Ontario 
L6S 6B7 
Canada

ACCO Australia
Level 2, 8 Lord St
Botany NSW 2019
PO Box 311
Rosebery NSW 1445
Australia

Complies with 21 CFR 1040.10 except for deviations 
pursuant to Laser Notice No.50,dated July 26,2001

AVOID EXPOSURE

LASER RADIATION IS EMITTED

FROM THIS APERTURE

LASER RADIATION-DO NOTSTARE INTO BEAMCLASS 
2 LASER PRODUCT MAXIMUM OUTPUT:<1mW 
WAVELENTH:650+20nm

Note:  The  Wireless  Presenter  with  Laser  Pointer/Wireless  Presenter  has  been  tested  and  found  to 

comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.  These limits are 

designed to provide reasonable protection against harmful interference in a residential installation.  This 

equipment  generates,  uses  and  can  radiate  radio  frequency  energy  and,  if  not  installed  and  used  in 

accordance with the instructions, may cause harmful interference to radio communications.  However, 

there is no guarantee that interference will not occur in a particular installation.  If this equipment does 

cause  harmful  interference  to  radio  or  television  reception,  which  can  be  determined  by  turning  the 

equipment off and on, the user is encouraged to try to correct the interference by one of the following 

measures: 

- Reorient or relocate the receiving antenna. 

- Increase the separation between the equipment and receiver. 

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

- Consult the dealer or an experienced radio/TV technician for help. 

 

FCC  Caution:  Any  changes  or  modifications  not  expressly  approved  by  the  party  responsible  for 

compliance could void the user's authority to operate this equipment. 

 

The Wireless Presenter with Laser Pointer/Wireless Presenter complies with Part 15 of the FCC Rules. 

Operation is subject to the following two conditions: (1) This device may not cause harmful interference, 

and  (2)  this  device  must  accept  any  interference  received,  including  interference  that  may  cause 

undesired operation. 

 

 

This device complies with RSS-210 of the Industry Canada Rules.  

Operation is subject to the following two conditions: (1) This device may not cause harmful interference, 

and  (2)  this  device  must  accept  any  interference  received,  including  interference  that  may  cause 

undesired operation. 

 

Ce  dispositif  est  conforme  a  la  norme  CNR-210  d'Industrie  Canada  applicable  aux  appareils  radio 

exempts de licence.  

Son  fonctionnement  est  sujet  aux  deux  conditions  suivantes:  (1)  le  dispositif  ne  doit  pas  produire  de 

brouillage  prejudiciable,  et  (2)  ce  dispositif  doit  accepter  tout  brouillage  recu,  y  compris  un  brouillage 

susceptible de provoquer un fonctionnement indesirable.