ACCO Brands M01132-M Manual Do Utilizador

2.4GHz Wireless Optical mouse Users’ Guide 

Installation 
1.    Plug the receiver into a USB port on your computer. 
2.    Insert battery into the mouse.   
3.    This mouse provides factory default ID and so the link will be set up after a while. 
4.    Click the mouse key and her response will be read on the monitor.   

 

1.  No connection between the mouse and the receiver.   

Re-insert the receiver. Try to insert receiver to another USB port on your computer. 

2.    No any response on the mouse. 

Take out the battery from the mouse and reinstall it with correct orientation. Try a 

new battery if necessary.   

 

Note: 
FCC statement: 
This equipment has been tested and found to comply with the limits for a Class B   
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to   
provide reasonable protection against harmful interference in a residential installation. 
This equipment generates, uses and can radiate radio frequency energy and if not   
installed and used in accordance with the instructions, may cause harmful interference 

to radio communications. However, there is no guarantee that   
interference will not occur in a particular installation. If this equipment does cause 
harmful interference to radio or television reception, which can be determined by   
turning the equipment off and on. The user is encouraged to try to correct    the 
interference by one of the following measures: 
Reorient or relocate the receiving antenna. 

 

Increase the separation between the equipment and receiver. 
Connect the equipment into an outlet on a circuit different from that to which the   
receiver is connected. 
Consult the dealer or an experienced radio/TV technician for help. 
To assure continued compliance, any changes or modifications not expressly approved   
by the party responsible for compliance could void the user’s authority to operate this   
equipment. (Example- use only shielded interface cables when connecting to computer 

or peripheral devices). 
This device complies with Part 15 of the FCC rules. Operation is subject to the following   
two conditions: 
(1) This device may not cause harmful interference, and 
(2) This device must accept any interference received, including interference that       

The manufacturer is not responsible for any radio or TV interference caused by   
unauthorized  modifications  to  this  equipment.  Such  modifications  could  void  the 

user authority to operate the equipment. 
 

compromettre le fonctionnement.