ACCO Brands M01309-D Manual Do Utilizador

This device complies with Part 15 of the FCC Rules. Operation is subject 

to the following two conditions: (1) this device may not cause harmful 

interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a 

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits 

are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, uses 

and can radiate radio frequency en

ergy and, if not installed and used in accordance with the instructions, 

may cause harmful interference to radio communications. However, there 

is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television 

reception, which can be determined by turning the equipment off and on, 

the user is encouraged to try to correct the interference by one or more 

of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to 

which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for 

compliance could void the user’s authority to operate the equipment.

This device complies with Industry Canada license-exempt RSS standard(s). 

Operation is subject to the following two conditions: (1) this device may not 

cause interference, and (2) this device must accept any interference, including 

interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux 

appareils radio 

exempts de licence. L'exploitation est autorisée aux deux conditions suivantes 

: (1) l'appareil ne 

doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter 

tout brouillage 

radioélectrique subi, même si le brouillage est susceptible d'en compromettre 

le fonctionnement.