Welite Corporation Limited LMT1009 Manual Do Utilizador
ON
OFF
ON
OFF
ON
OFF
[I]
[I]
[II]
[II]
[I]+[II]
[I]+[II]
INSTALLATION:
Receiver LMR-400 (Refer to Fig. 1)
Receiver LMR-400 (Refer to Fig. 1)
z
Disconnect main power before installation.
z
Connect AC wire (Live & Neutral) to receiver block terminal IN.
z
Connect Load wires into receiver block terminal OUT (Port I & Port II) .
z
Connect main power on.
OPERATION :
1. Transmitter
1. Transmitter
LMT-1009
(Refer to Fig. 2)
z
Main [I] “ON” button:
Turns on main [I] light
z
Main [I] “OFF” button:
Turns off main [I] light
(Refer to Fig. 3)
z
Secondary [II] “ON” button:
Turns on main [II] light
z
Secondary [II] “OFF” button: Turns off main [II] light
z
“DELAY OFF” button:
Turns off automatically after 10 seconds.
z
“Security mode”:
Randomly turns on & off the lights.
To activate, hold both “ON and OFF” button of Main [I] for 3 seconds.
To deactivate, simply press any button on the transmitter.
To activate, hold both “ON and OFF” button of Main [I] for 3 seconds.
To deactivate, simply press any button on the transmitter.
※REMARK※
In order to operate with a transmitter, the mechanical switch must be powered “ON”
2. Mechanical Switch (Refer to Fig. 4)
In order to operate with a transmitter, the mechanical switch must be powered “ON”
2. Mechanical Switch (Refer to Fig. 4)
z
1
st
time “ON” will control the main [I] light
z
2
nd
time “ON” will control the secondary [II] light
z
3
rd
time “ON” will control both main [I] and secondary [II] light.
HOW TO LINK CODE:
z
To start, program transmitter with receiver.
z
Connect power to receiver
z
Switch ON first then OFF and ON cycle for 6 times, this will enter learning mode.
While in learning mode, the main [I] light connected to receiver will flash to indicate ready for programming.
While in learning mode, the main [I] light connected to receiver will flash to indicate ready for programming.
z
Then on transmitter press the main [I] “ON” button once, main [I] and secondary [II] light will flash 2 times to indicate
programming is confirmed and completed.
programming is confirmed and completed.
！
During leaning mode if within 12 seconds no signal is detected it will automatically return to stand-by
mode.
Fig. 2
Fig. 3
Fig. 4