Arris 3387W Manual Do Utilizador
190
About CONFIG Commands
You reach the configuration mode of the command line inter-
face by typing
face by typing
configure
(or any truncation of
configure
, such
as
con
or
config
) at the CLI SHELL prompt.
CONFIG Mode Prompt
When you are in CONFIG mode, the CLI prompt consists of the
name of the Cayman Gateway followed by your current
name of the Cayman Gateway followed by your current
node
in
the hierarchy and two right angle brackets (>>). For example,
when you enter CONFIG mode (by typing
when you enter CONFIG mode (by typing
config
at the SHELL
prompt), the Coconut (top)>> prompt reminds you that you
are at the top of the CONFIG hierarchy. If you move to the ip
node in the CONFIG hierarchy (by typing ip at the CONFIG
prompt), the prompt changes to Coconut (ip)>> to identify
your current location.
are at the top of the CONFIG hierarchy. If you move to the ip
node in the CONFIG hierarchy (by typing ip at the CONFIG
prompt), the prompt changes to Coconut (ip)>> to identify
your current location.
Some CLI commands are not available until cer tain conditions
are met. For example, you must enable IP for an inter face
before you can enter IP settings for that inter face.
are met. For example, you must enable IP for an inter face
before you can enter IP settings for that inter face.
Navigating the CONFIG Hierarchy
•
Moving from CONFIG to SHELL
— You can navigate from
anywhere in the CONFIG hierarchy back to the SHELL level by
entering
entering
quit
at the CONFIG prompt and pressing R
ETURN
.
Dogzilla (top)>> quit
Dogzilla >
Dogzilla >
•
Moving from
top
to a subnode
— You can navigate from
the top node to a subnode by entering the node name (or the
significant letters of the node name) at the CONFIG prompt
and pressing R
significant letters of the node name) at the CONFIG prompt
and pressing R
ETURN
. For example, you move to the IP subn-
ode by entering ip and pressing R
ETURN
.