Fimi Srl 802180 Manual Do Utilizador
VERIFICATION ONLY
8
NOT RELEASED
• When recharging the NGP1 Computing Platform batteries, make sure
the power plug and outlet are easily accessible.
• Detach the power cable or DC power cord only when the unit is off or
when there is a charged battery inserted.
• Do not use the NGP1 Computing Platform without battery pack
inserted and the battery door opened as objects or dirt may enter in
the slot.
the slot.
IMPORTANT: Depending on the application, it is advised to activate a
power management scheme or a screen saver. If a still image in high
contrast remains on the screen for an extended period of time, it may leave
an 'after-image' or 'ghost image' on front of the screen. This is a well
an 'after-image' or 'ghost image' on front of the screen. This is a well
known phenomenon that is caused by the shortcomings inherent in LCD
technology. In most cases, the afterimage will disappear gradually over a
technology. In most cases, the afterimage will disappear gradually over a
period of time after the power has been switched off. Be aware, that the
afterimage symptom cannot be repaired and is not covered under
warranty.
warranty.
1.3.3 Installation Locations
The NGP1 Computing Platform is a transportable device, but not a portable equipment.
Then its use is stationary, leant on a table, in the positions sets by its kickstand, with the
screen facing the user. The kickstand is part of the Medtronic Patient Interface component
screen facing the user. The kickstand is part of the Medtronic Patient Interface component
and then further instructions on location and use of the NGP1 Computing Platform will be
given with the overall user manual of the Medtronic Carelink Encore Programmer. The
NGP1 Computing platform is a component of it and other subsystems are the Medtronic
given with the overall user manual of the Medtronic Carelink Encore Programmer. The
NGP1 Computing platform is a component of it and other subsystems are the Medtronic
Patience Interface(MPI) and associated Firmware, cables and software.
Anyhow, in any circumstance, please follow the below recommendations:
Anyhow, in any circumstance, please follow the below recommendations:
• Do not place the NGP1 Computing Platform in an unsteady location.
If the NGP1 Computing Platform is placed in an unsteady location,
such as on an unstable stand or incline, the NGP1 Computing
such as on an unstable stand or incline, the NGP1 Computing
Platform may drop or tip over and cause injury
• Do not store or use the NGP1 Computing Platform in locations
exposed to heat, direct sunlight or extreme cold.
• Avoid moving the NGP1 Computing Platform between locations with
large temperature differences. Choose a site that falls within the
following temperature and humidity ranges.
• Temperature: 5- 40°C equivalent to 41-104°F
• Humidity: 15-93% RH
• The NGP1 Computing Platform is a semi-ruggedized device but it is
strongly recommended to not subject it to severe vibrations, do not
drop it or subject it to other mechanical shocks or high impact
conditions.
conditions.
• Take care not to mishandle this product by either knocking or
dropping it during operation or transportation
• The enclosure of NGP1-FCP has to be checked upon collision
damage; in this case, please refers to qualified personnel.
1.3.4 Setup precautions
Instructions on Setup precautions of the NGP1 Computing Platform will be given with the
overall user manual of the Medtronic Carelink Encore Programmer. The NGP1 Computing
platform is a component of it
overall user manual of the Medtronic Carelink Encore Programmer. The NGP1 Computing
platform is a component of it
Anyhow, in any circumstance, please follow the below recommendations