Exicom Limited EX7100-1 Manual Do Utilizador

 

EX7100 Technical Manual - Installation of Antenna and Equipment 

 

©1999 Exicom Technologies (1996) Ltd 

2-1 

Issue 2 - February 2001 

 

 

 

 

 

Although EX7100 Radio Link terminals can be installed in any order, the following 
sequence should be followed to ensure that minimum time is spent on installation. 

> 

Install Exchange antenna (Section 2.3), 

> 

Mount the Exchange terminal (Sections 2.4 and 2.5), 

> 

Connect power, antenna and interface cables to the Exchange terminal (Section 2.6), 

> 

Configure and test Exchange terminal (Section 3), 

> 

Repeat the above steps for the installation of the Subscriber antenna, Subscriber 
terminal and cabling (Sections 2.3 to 2.6 inclusive and Section 3), 

> 

Final antenna alignment at Subscriber site (Section 2.11), 

> 

Final antenna alignment at Exchange site (Section 2.11). 

> 

Establish a test link to confirm operation of system (Sections 4.3.1 and 4.3.2), 

Note:  Ensure that the correct terminal is dispatched to the appropriate site (Terminal 

information can be found on a label on the side of the packing box). 

Antenna sites for the EX7100 installation should have been chosen as part of the system 
planning process (Refer to Section 1.6). If they have not been selected, contact your 
Exicom International Supplier. 

Radio path planning is a highly technical procedure and should only be performed by a 
qualified person. 

THIS EQUIPMENT MUST ONLY BE INSTALLED AND 
MAINTAINED BY SERVICE PERSONNEL