Advance Security Inc R40 Manual Do Utilizador

CE400

Transmitter Operation and Programming

• Programming transmitter

This receiver/Module can program up to 4 different transmitters for each channel output

Enter:

1. Use a small screwdriver to press the programming switch until the LED start to flash (about 2 seconds) the release
2. Within 10 seconds press any transmitter button and hold it until the LED solid on (The transmitter programmed), then

release the button.

3. Wait until the LED flashing again.
4. To program second ~ fourth transmitters, wait got LED flashing again and repeat steps 2 ~ 3.

Exit:

1. Press the program switch 1 times again. (Blue LED turn-off)

2. Or, leave it for about 10 seconds, it will automatically exit.

Note:

If more than 4 transmitter’s codes programmed, the system only keeps the very last 4 codes. The previous codes will void
automatically. (eg. You already programmed 4 codes into the system. You may program additional codes No. 5 and 6 into the
system, the codes No. 1 and 2 will be void while codes No 3 ~ 6 stays.

• Programming timer output:

This receiver/module can select 6 different timer output modes

Enter:

1. Use a small screwdriver to press the programming switch and hold it until the LED starts flashing slow (about 2 second),

then release

2.  Then press programming switch 3-times again
3.  The LED will start to flash, and the timer output programming mode status (see below chart)
4.  Push the transmitter button (The one you just programmed) to select desirable output timer mode.
5.  If LED with 1 flash … pause (0.5-second mode). To select the next mode press the button one time to change to the next

timing output, that is 1.0-second mode.

6. If LED with 5 flashes … pause (Momentary mode), to select 1-second mode, press the button 3 times.

Output Timer Mode

LED Status

0.5 second timer output

1 flash ... pause

1 second timer output

2 flash ... pause

2 second timer output

3 flash ... pause

3 second timer output

4 flash ... pause

Momentary pulse output

5 flashes ... pause

Latch output

6 flashes ... pause

Note:

In each mode the LED will flash 5 times, (eg. In latch mode, LED will flash, "6 flashes ... pause" for 5 times.) Allowing you to
check the current mode status. If there is no transmitter button pressed over the 9 times flashing, the system would
automatically exit the programming timer output.

Exit:

1. Press the program switch again. (LED off)
2. Or, leave the LED to flash for 5 times, it will automatically exit.