Seiko Epson Corporation FBWLU6117 Manual Do Utilizador

Página de 9
USA - Federal Communications Commission (FCC)   
FCC Radiation Exposure Statement   
Interference Statement   
These devices comply with Part 15 of the FCC Rules. Operation of the devices 
is subject to the following two conditions: (1) The devices may not cause 
harmful interference, and (2) The devices must accept any interference that 
might cause undesired operation. 
 
This equipment has been tested and found to comply with the limits for a Class 
B digital device, pursuant to Part 15 of the FCC Rules. These limits are 
designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses, and can radiate radio 
frequency energy. If the equipment is not installed and used in accordance with 
the instructions, the equipment might cause harmful interference to radio 
communications. There is no guarantee, however, that such interference will 
not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception (which can be determined by 
turning the equipment off and on), the user is encouraged to try to correct the 
interference by taking one or more of the following measures: 
  Relocate this device.     
  Increase the separation between the device and the receiver.     
  Connect the device into an outlet on a circuit different from that of other 
electronics.     
  Consult the dealer or an experienced radio technician for help. 
 
FCC  Caution:  Any  changes  or  modifications  not  expressly  approved  by  the 
party responsible for compliance could void the user's authority to operate this 
equipment. 
 
This  transmitter  must  not  be  co-located  or  operating  in  conjunction  with  any 
other antenna or transmitter. 
 
Radiation Exposure Statement:
 
This  equipment  complies with  FCC radiation  exposure limits  set  forth  for an 
uncontrolled  environment.  This  equipment  should  be  installed  and  operated 
with minimum distance 20cm between the radiator & your body. 
 
This device is intended only for OEM integrators under the following conditions: