Scientific Toys Ltd 4612-24GR Manual Do Utilizador

(For maximum performance, use alkaline batteries)

Remember to take out all batteries from vehicle and transmitter after playing.

1.  Do not mix old and new batteries.

2.  Do not mix alkaline, standard (Carbon-Zinc), or rechargeable batteries.

It is recommended that this toy and all accessories be periodically examined 

for potential hazards and that any potentially hazardous parts be repaired 

or replaced.

1.  Make sure the “ON/OFF” switch at the underside of the vehicle is at the 

  “OFF” position. (See Diagram 1) 

2.  Unscrew to open the battery cover. (See Diagram 1) 

3.  Insert 5 “AA” batteries by matching the (+) and (–) signs as indicated in 

  the battery compartment.  

4.  Replace the battery lid. 

1.  Remove battery cover and install 2 “AA” batteries by matching 

  (+) and (–) poles as indicated in the battery compartment.

2.  Replace the battery cover.

Note: Remove battery after you have finished using your vehicle.

1.  Turn ON the vehicle (See diagram #4).

2.  Install 2 x AA batteries into the transmitter. The pairing LED light on the 

  transmitter will flash (See diagram #3).

3.  If pairing is successful, the pairing LED light will turn OFF

4.  You must pair the transmitter with the vehicle within 45 seconds. After 

  45 seconds you must push the control on the transmitter to pair again.

5.  You must repeat the pairing process again when the transmitter needs 

  batteries replaced.

6.  Operate the vehicle with the transmitter. (See Diagram #6)

7.  After playing, slide the ON/OFF switch to the "OFF" position of the vehicle.

1.  If the vehicle does not drive straight, adjust the Steering Alignment Lever 

  on the underside of the vehicle. (See Diagram #6)

2.  If the vehicle turns to the left, turn the Steering Alignment Lever towards "R".

3.  If the vehicle turns to the right, turn the Steering Alignment Lever towards "L".

(Diagram #1)   <1>  On/Off switch

   

<2>  Battery cover

   

<3>  Locking latch

(Diagram #2)  <4>  5 x AA batteries

(Diagram #3)  <5>  Unscrew to open the battery cover

   

<6>  2 x AA batteries

   

<7>  LED

(Diagram #4)  <8>  On

(Diagram #5)  <8>  How to play

(Diagram #6)  <9>  Steering alignment lever 

   

 

1.   Do not charge battery pack that is hot, wet or shows leakage or corrosion.

2.   May explode if disposed of in fire!

3   Do not disassemble the battery pack.

4.  Non-rechargeable batteries are not to be recharged.

5.  Rechargeable batteries are to be  removed from the toy before being 

  charged.

6.  Rechargeable battery is only to be charged by adults or by children at 

  least 8 years old. 

7.  Different types of batteries or new and used batteries are not to be mixed.

8.  Only batteries of the same or equivalent type as recommended are to 

  be used.

9.  Batteries are to be inserted with the correct polarity.

10. Exhausted batteries are to be removed from the toy.

11. The supply terminals are not to be short-circuited.

12. The antenna wires are not to be inserted into socket outlet.

This device complies with Part 15 of the FCC Rules. Operation is subject to the 

following two conditions: 

(1) this device may not cause harmful interference, and (2) this device must 

accept any interference received, including interference that may cause 

undesired operation. Warning: Changes or modifications to this unit not 

expressly approved by the party responsible for compliance could void the 

user’s authority to operate the equipment. NOTE: This equipment has been 

tested and found to comply with the limits for a Class B digital device, 

pursuant to Part 15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a residential installation. 

This equipment generates, uses and can radiate radio frequency energy and, 

if not installed and used in accordance with the instructions, may cause harmful 

interference to radio communications. However, there is no guarantee that 

interference will not occur in a particular installation. If this equipment does 

cause harmful interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is encouraged to 

try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which 

  the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Battery/Batteries should be installed by adult only. The toy is not intended for 

children under 3 years old.

Keep packing for reference since it contains important information.

Exhausted batteries are to be removed from the toy.

WARNING:

NOT SUITABLE FOR CHILDREN UNDER THE AGE OF 36 MONTHS AS 

SMALL PART(S) AND ENTANGLEMENT/

STRANGULATION HAZARDS.

PACKAGING MATERIALS ARE NOT TOYS.

PLEASE REMOVE ALL PACKAGING AND PACKING TAGS/WIRES BEFORE 

GIVING THIS TOY TO YOUR CHILD.

COLOUR, DESIGNS AND DECORATIONS MAY VARY FROM THOSE 

SHOWN IN THE PHOTOGRAPHS.

HAIR ENTANGLEMENT MAY RESULT IF THE CHILD'S HEAD IS TOO 

CLOSE TO THE MOTORISED UNIT OF THIS TOY.