HM Electronics Inc C2KS Manual Do Utilizador
SUPPLEMENTARY OPERATING INSTRUCTIONS
HM ELECTRONICS, INC.
14110 Stowe Drive, Poway, CA 92064 USA
!
!
!
!
!
Phone: 1-800-848-4468 Fax: (858) 552-0172
These instructions are intended to supplement the operating instructions for your HME Drive-Thru
Audio System as follows.
Audio System as follows.
•
All references to the “COM2000” should be changed
to “COM2000BP.”
to “COM2000BP.”
•
The section of the manual referring to “OPERATING
THE SYSTEM” should be supplemented with the
following information. This information updates
instructions for operation of the Communicator.
THE SYSTEM” should be supplemented with the
following information. This information updates
instructions for operation of the Communicator.
I.
COM2000BP FREQUENCY AND TONE SWITCH SETTINGS
You may need to make adjustments to a
Communicator to match its operating fre-
quency and tone settings to those of your
HME wireless communication system,
especially if you add a new Communicator
to an existing system. To do this, open the
battery compartment of the new Communi-
cator and of a working Communicator and
remove their batteries. Compare the DIP
switch settings the two Communicators.
If they are different, change the switch
settings of the new unit to match the
settings of the working unit, using a
straightened paper clip. DO NOT use a
pencil or any object that can break off and
fall into the Communicator. Be certain the
switches are adjusted fully to the ON or
OFF position. If further assistance is
required, contact HME Technical
Support at 1-800-848-4468.
Communicator to match its operating fre-
quency and tone settings to those of your
HME wireless communication system,
especially if you add a new Communicator
to an existing system. To do this, open the
battery compartment of the new Communi-
cator and of a working Communicator and
remove their batteries. Compare the DIP
switch settings the two Communicators.
If they are different, change the switch
settings of the new unit to match the
settings of the working unit, using a
straightened paper clip. DO NOT use a
pencil or any object that can break off and
fall into the Communicator. Be certain the
switches are adjusted fully to the ON or
OFF position. If further assistance is
required, contact HME Technical
Support at 1-800-848-4468.
COM2000BP
Latching COMMUNICATOR
®
®
®
®
®
HME# 400438
Rev C 5/12/04
Figure 2. DIP Switches inside Communicator
battery compartment
battery compartment
Figure 1.
COM2000BP COMMUNICATOR
COM2000BP COMMUNICATOR
©
For a new Communicator to be used with an existing Drive-Thru Audio System, follow
the instructions in section I. below, and refer to Figure 2.
the instructions in section I. below, and refer to Figure 2.