HM Electronics Inc HS6100 Manual Do Utilizador
HS6100
HM ELECTRONICS, INC.
14110 Stowe Drive, Poway, CA 92064 USA
• Phone: 1-800-848-4468 Fax: (858) 552-0172
HME# 400G653
Rev A 6/22/10
Rev A 6/22/10
Wireless Headset
OPERATING INSTRUCTIONS
Power
light
Power
button
button
SETUP
Power On/Off
To turn the power on
Press and release the red power button on the headset
earpiece. A voice message in the earpiece will say
“Headset #, Battery Full/Half/Low” and the red power
light will begin blinking. See Figure 1.
earpiece. A voice message in the earpiece will say
“Headset #, Battery Full/Half/Low” and the red power
light will begin blinking. See Figure 1.
To turn the power off
Press and hold the power button for approximately
3 seconds. A voice message in the earpiece will say
“Headset off,” and the power light will go off.
3 seconds. A voice message in the earpiece will say
“Headset off,” and the power light will go off.
Figure 1. Headset power button
and power light
Configure Headset
Start with power OFF and press any of the following button combinations while turning the power ON.
Immediately release all buttons after pressing the power button. Each of these settings has an
associated voice prompt. Listen to the voice prompt to confirm the setting.
Immediately release all buttons after pressing the power button. Each of these settings has an
associated voice prompt. Listen to the voice prompt to confirm the setting.
• Hands Free (HF) on/off – Press and hold B and the
UP arrow
S while you press the power button to turn
the headset on in the HF mode. With the power off,
press and hold B and the DOWN arrow
press and hold B and the DOWN arrow
T while you
press the power button to turn off the HF mode.
Figure 2. Headset buttons
B
T
A1
A2
S
• Auto HF (AHF) – Press and hold A1 or A2 and the
UP arrow
S while you press the power button to turn
the headset on in the Auto HF mode. Set the base
transceiver switch K1-3 to on (See Figure 4). When
you turn the unit off, the AHF mode will not be saved.
transceiver switch K1-3 to on (See Figure 4). When
you turn the unit off, the AHF mode will not be saved.
• “B” Channel HF (BHF) – Press and hold B and A2
while you press the power button to turn the headset
on in the BHF mode. This will keep the B channel
open to allow hands-free communication with other
crew members. If a customer arrives, B-channel
communication will automatically be interrupted to
allow communication with the customer on A1 or A2.
on in the BHF mode. This will keep the B channel
open to allow hands-free communication with other
crew members. If a customer arrives, B-channel
communication will automatically be interrupted to
allow communication with the customer on A1 or A2.
• Language selection – To change between English and another language, press and hold A1 and the
DOWN arrow
T while you press the power button to turn the headset on. Doing this again changes
back to the first language.
• Play status – Press A2 and the DOWN arrow T while you press the power button to turn the
headset on. An example of the status you will hear is: “Headset #, Battery Full/Half/Low,
English/Espanol, Hands-free on/off, firmware version #.”
English/Espanol, Hands-free on/off, firmware version #.”