Tait International Limited TBCK4B Manual Do Utilizador
DRAFT 4
102
Replacing Modules
TB9400 Installation and Operation Manual
© Tait Electronics Limited September 2011
8.6
Replacing the Front Panel Fans
The following instructions refer to
Important
You must replace each fan duct assembly in its original loca-
tion in the front panel. Each module, or pair of modules,
requires a specific type of fan duct to ensure the cooling air
flow passes directly through the modules’ heatsinks.
tion in the front panel. Each module, or pair of modules,
requires a specific type of fan duct to ensure the cooling air
flow passes directly through the modules’ heatsinks.
If a cooling fan has failed and you are fitting a replacement front panel, you
must also fit the correct type of front panel for that
must also fit the correct type of front panel for that
base station
. Each type
of
base station
has a different combination of modules, and must use a front
panel fitted with fan ducts that match those modules.
The front panel for a 100 W
base station
has different fan ducts from the
front panel for a 50 W
base station
, as shown in
. In a 50 W
base
station
, the fan duct for reciter and PA 1 is slightly different from the duct
for reciter and PA 2. Each duct is designed to fit only in its correct position.
Removal
1.
2.
Reciter and 50 W PA Fan
a. Unplug the fan from the front panel board (
b
or
c
).
b. Remove the four screws labeled
d
or
e
and remove the fan duct
assembly from the front panel.
c. Remove the fours screws holding the fan into the duct and
remove the fan.
3.
100 W PA Fan
d. Unplug the fan from the front panel board
f
.
e. Remove the four screws labeled
g
and remove the fan duct
assembly from the front panel.
f. Remove the fours screws holding the fan into the duct and
remove the fan.
4.
PMU Fan
a. Remove the 100 W PA or reciter and 50 W PA 2 fan duct assembly
as described above.
b. Unplug the PMU fan from the front panel board
h
.
c. Remove the two screws labeled
i
and remove the PMU fan duct
assembly.
d. Remove the fours screws holding the fan into the duct and
remove the fan.