Tait International Limited TBCK4B Manual Do Utilizador
DRAFT 4
106
Replacing Modules
TB9400 Installation and Operation Manual
© Tait Electronics Limited September 2011
8.8
Replacing the Subrack Interconnect Board
Removal
1.
2.
Disconnect any system control bus cables and DC power cables from
the subrack board.
the subrack board.
3.
Remove the three M3 nuts and spring washers
b
securing the right
end of the board to the subrack.
4.
Remove the D-range cover
c
.
5.
Remove the two retaining clamps
d
securing the left end and centre
of the board.
6.
Remove the board.
Refitting
1.
If previously removed, replace the insulator
e
.
2.
Refit the board and D-range cover, and secure with the M3 nuts and
spring washers. Replace the two retaining clamps.
spring washers. Replace the two retaining clamps.
3.
Figure 8.2
Replacing the subrack interconnect board
b
e
c
d
x3