Tait International Limited TBCK4B Manual Do Utilizador
DRAFT 4
TB9400 Installation and Operation Manual
Working with Base Stations from Your PC
51
© Tait Electronics Limited September 2011
8.
Select the User configured option, and then enter a number that is on
the same subnet as the
the same subnet as the
base station
. For example, if the TB9400 has
IP 192.168.1.2, enter 192.168.1.1 for the PC.
9.
Enter a suitable subnet mask, for example 255.255.255.0.
The web browser should now be able to connect to any physically
connected
The web browser should now be able to connect to any physically
connected
base station
that is on the same subnet.
10.
Once the web browser session is finished, re-connect the local area
network cable to the PC. The PC then uses its normal TCP/IP
properties.
network cable to the PC. The PC then uses its normal TCP/IP
properties.
Windows 2000
1.
Remove the local area Ethernet connection and connect an Ethernet
patch cable between the PC and the
patch cable between the PC and the
base station
. You can use either
a straight through or crossover Ethernet patch cable with the current
base station
firmware.
2.
Select Start > Settings > Network and Dialup Connections.
3.
Double-click the Local Area Connection icon.
4.
Click Properties.
5.
Click Internet Protocol (TCP/IP), and then click Properties.
6.
Note the current settings so that you can restore them later.
7.
Select Use the following IP address, and then enter a number that
is on the same subnet as the
is on the same subnet as the
base station
. For example, if the
base
station
has IP 192.168.1.2, enter 192.168.1.1 for the PC.
8.
Enter a suitable subnet mask, for example 255.255.255.0.
The web browser should now be able to connect to the
The web browser should now be able to connect to the
base station
.
9.
When you have finished the web browser session, re-connect the
local area network cable to the PC and then restore the original PC
configuration. When you close the Network connection dialog box,
the restored configuration is applied.
local area network cable to the PC and then restore the original PC
configuration. When you close the Network connection dialog box,
the restored configuration is applied.
4.2.5
Troubleshooting Connection Problems
If the attempt to connect to a
base station
failed, consider these possible
causes.
1.
Your PC is part of your organization’s LAN and does not belong to
the same subnet as the
the same subnet as the
base station
. Give the PC a suitable IP address
and subnet mask as described in
.
2.
You are attempting to connect to the wrong IP address. Check that
the IP address is correct.
the IP address is correct.