Tait International Limited TMBH7A Manual Do Utilizador

Diagnostics tests are available via the main menu.

This feature is controlled by a software license 
(SFE) and may not be available with your radio.

1 Press Menu and select Diagnostics.

2 Scroll to the name of the test you want to run and 

press Select.

The following table lists diagnostics tests you may find 
on your radio.

Notice  The radio may transmit when you select some 
tests. Make sure you have a suitable load or antenna 
connected before running diagnostics tests.

Audio loopback 
test

Routes audio from the microphone to the radio’s 
internal and external speakers.
Before running this test, turn the volume down to 
limit interference and reduce the impact of audio 
artefacts.

Display freq

Displays the transmit and receive frequencies of the 
current channel. If the radio is scanning this 
information may not be available.

GPS NMEA 
data

Displays the last raw data received from a GPS 
antenna/receiver connected to the radio. The radio 
will display all supported sentence formats received 
(for example $GPRMC and $GPGGA sentences). 
Note that the display will not automatically refresh 
when new data is received.

Keypad test

Sounds an audible tone when a key is pressed or 
released on the radio. The radio also displays the 
key name along with “pressed” or “released”.

QoS

Displays information about the quality of service 
(received signal strength (RSSI) with an indication of 
digital voice quality).

RSSI

Displays the received signal strength (RSSI) of the 
current channel.

Rx 1011 or 
RX1031

Receives a 1031 Hz or 1011 Hz tone and displays 
the received signal strength (RSSI) and the bit error 
rate (BER) of the received signal.