Digital Monitoring Products Inc PC0101 Manual Do Utilizador

2

3

When a Panic Alarm is sent, the LED is on steady for five (5) minutes and then turns off.  When a Panic Test is sent to 

the 1118 from the 1100 Series Receiver, the LED flashes quickly for five (5) minutes and then turns off.  

Mount the 1118 on a flat surface such as a wall or single-gang box.  When using plug-in power supply operation, 

mount the 1118 near a wall outlet.  See Figure 2 for mounting hole locations.

Red LED 

(Survey)

Tamper

Switch

Red Remote

IndicatorLight

Mounting Holes

+

3.0V

Lithium
Battery

—

Internal
Antenna
Location

Power Supply

Adapter Plug 

Housing

EXT

BAT

The 1118 output can be powered by: 

•  CR123A 3.0 VDC battery
•  Model 376 plug-in power supply
•  12 VDC Power Supply 

Battery Power
Observe polarity when installing the battery.  Use only 3.0V Lithium batteries, DMP Model CR123, or the equivalent 

battery from a local retail outlet.  Do not connect the power supply when operating using battery power.
Note: When setting up a wireless system, it is recommended to program outputs and connect the receiver 

1. Squeeze the cover left and right sides together to remove.  See Figure 1.  
2. Install a jumper on the two J1 pins next to BAT to enable battery operation.
  Note:  Battery operation is not enabled if the jumper is on the J1 pins next to EXT.
3. If replacing the battery, remove the old battery and dispose of it properly.
4. Place the 3.0V Lithium battery in the holder and press into place.  See Figure 3 for Battery location.
5. Snap the cover back into place.

  Caution: Properly dispose of unused batteries.  Do not recharge, disassemble, heat above 212°F (100°C), 

 

or incinerate.  Risk of fire, explosion, and burns.