Honeywell International Inc. 8DL5811 Manual Do Utilizador

800-03928  2/09  Rev. A 

One Zone Door/Window Transmitter 

 

Model 5811 is a single zone Door/Window 
Transmitter, compatible with alarm systems that 
support 5800 series wireless devices. 5811 has a 
unique serial number permanently assigned 
during manufacture, which must be entered into 
the control panel upon installation. Refer to the 
panel’s installation instructions for programming 
details. 
 
Note:  During programming of the control unit, 
5811 transmitters should be treated as “RF” (i.e. 
supervised RF) Type (mandatory for UL 
installations).  
 
MOUNTING 
Choose a mounting location for 5811 where the 
device is stationary and the magnet is mounted 
to the moving part of the door or window.  

 

Before mounting 5800 permanently, conduct 
Go/No Go tests (see control’s instructions) to 
verify adequate signal strength from the 
mounting location. 
 
1.

  Mount using double-faced tape (supplied) 

by affixing it to the back of the unit and 
mounting the unit in place.  Use screws 
(optional) if desired.   Warning:  Do not 
mount unit in a location where 
temperature may approach the freezing 
point (32°F / 0°C). 

2.

  Mount the magnet (supplied) near the 

alignment marks on the case (see Diagram). 

BATTERY REPLACEMENT 
1.

  Open housing by inserting a flat blade 

screwdriver into latch and twisting gently.   

 
2.

  Remove old battery cell.   

 
3.

  Observe proper polarity (see diagram) then 

insert new battery so it is held by plastic 
retaining clip. 

 
4.

  Engage the case tabs (see diagram), then 

rotate the housing to close. Engage latch 
with firm pressure.  

5811-003-V1

REED

LATCH

MOUNT 5811 TO 
STATIONARY SURFACE

R

O

T

A

T

E

TO

CL

OS

E

MOUNT MAGNET 

TO MOVEABLE 

SURFACE

MOUNTING

HOLES

 

 

FEDERAL COMMUNICATIONS 
COMMISSION STATEMENTS:  The user shall 
not make any changes or modifications to the 
equipment unless authorized by the Installation 
Instructions or User's Manual. Unauthorized 
changes or modifications could void the user's 
authority to operate the equipment. 
 
FCC / IC STATEMENT:  This device complies 
with Part 15 of the FCC Rules, and RSS 210 of 
IC. Operation is subject to the following two 
conditions: (1) This device may not cause 
harmful interference (2) This device must 
accept any interference received, including 
interference that may cause undesired 
operation. 
 
SPECIFICATIONS 
Dimensions 
2-1/8” (55mm) x 1-3/16” (30mm) x 1/4” (7mm) 
 
Replacement Battery 
Renata/Sanyo/Panasonic CR2032 
 
 
WARRANTY INFORMATION 
For the latest warranty information, please visit: 
 
www.honeywell.com/security/hsc/resources/wa 
 

 
 
 
 

 

Copyright © 2008 Honeywell International Inc.

www.honeywell.com/security

 

 

Ê800-03928^Š 

800-03928   2/09     Rev. A