N. V. Nederlandsche Apparatenfabriek NEDAP ADRRFMD Manual Do Utilizador

Page 

 of 

45

59

Manual iSense Lumen series

1.  

2.  

3.  

4.  

Please note that when doing a factory reset, all settings and configuration of the unit are lost. The

firmware version does not change.

Firmware change

There are four ways to change the firmware version on a Renos-based system:

Local - single unit over-write. The over-write can be executed by inserting a USB stick with the right

firmware into the USB port.

Local - complete system over-write. The over-write can be executed during the configuration wizard

with files on your laptop.

Local - complete system update. The update can be executed during the configuration wizard with files

on your laptop.

Device Management update. The update can be executed via the Device Management service.

If the system is integrated with a 3rd party system, please confirm the firmware version with that 3rd

party before installing it.

Firmware over-write Local - single unit over-write

Download the correct firmware image file from the Nedap Retail portal. Extract this file to a USB stick. Turn off

the power of the system. Insert the USB stick in the USB port of a Renos unit. Power the system. Wait until

LEDs 4, 5 and 6 are off again. This can take around ten minutes. Then turn off the power again, remove the USB

stick and turn on the power.

Please note that when using 'local - single unit flash' firmware change, all settings and configuration

of the unit are lost.

It's only possible to execute this on-site and not remotely, as the system needs to be re-configured

before it is usable again.