N. V. Nederlandsche Apparatenfabriek NEDAP SENSITGW Manual Do Utilizador
SENSIT SYSTEM | MANUAL
Mounting The SENSIT Surface Mount
58/111
Mounting The SENSIT Surface Mount
REPLACEMENT
When the battery life of the SENSIT Surface Mount fails after specified lifetime, we
advise to replace the core. The core part of the SENSIT Surface Mount is fully sealed
and for outdoor use, therefore batteries cannot be replaced.
advise to replace the core. The core part of the SENSIT Surface Mount is fully sealed
and for outdoor use, therefore batteries cannot be replaced.
SSENSIT Surface Mount r
r
eplacement procedure
Step 1:
Remove core
Remove core
The mounting ring can remain
positioned in the parking space. The
core can be unscrewed using a TORX
screwdriver. Unscrew the core by
opening the 4 screws in the core part of
the SENSIT Surface Mount using a T20
size bit screwdriver. Twist the core to lift
up.
positioned in the parking space. The
core can be unscrewed using a TORX
screwdriver. Unscrew the core by
opening the 4 screws in the core part of
the SENSIT Surface Mount using a T20
size bit screwdriver. Twist the core to lift
up.
Step 2:
Replace core
Replace core
Place a new core into the mounting ring
by aligning the marks on the core part
with the marks on mounting ring as
indicated in figure 9. Strongly push
down the core and secure with 4 screws.
Write down the correct ID numbers of
the replaced core on your installation
plan.
by aligning the marks on the core part
with the marks on mounting ring as
indicated in figure 9. Strongly push
down the core and secure with 4 screws.
Write down the correct ID numbers of
the replaced core on your installation
plan.
Step 3:
Activating
(Segmentation)
Calibration
Activating
(Segmentation)
Calibration
Activate the sensor, perform
segmentation when needed and
calibrate. Do this according the
procedures for with or without the
Configuration Tool as described in the
previous chapter.
segmentation when needed and
calibrate. Do this according the
procedures for with or without the
Configuration Tool as described in the
previous chapter.
SStep 4
4
::
Update SIS
Ensure to note the node ID number of
the SENSIT Surface Mount to the parking
bay and update the parking bay
configuration list in the SENSIT Interface
Software (SIS), see chapter 17.8.2
the SENSIT Surface Mount to the parking
bay and update the parking bay
configuration list in the SENSIT Interface
Software (SIS), see chapter 17.8.2
Note
Once out of the
transport/stock mode the
battery lifetime starts to
count.
Note
Also ensure not metal parts
(such as tools) aren’t
positioned in the
surrounding of the sensors
as this might affect
calibration.