N. V. Nederlandsche Apparatenfabriek NEDAP SENSITGW Manual Do Utilizador
SENSIT SYSTEM | MANUAL
MOUNTING THE SENSIT DISPLAY
61/111
MOUNTING THE SENSIT DISPLAY
15 MOUNTING THE SENSIT DISPLAY
The SENSIT Display enables signage of available parking spaces for stand-alone
parking guidance installations. The display is designed for outdoor use, indicating
the number of available parking spaces per parking lot thus guiding motorists to the
closest parking space.
parking guidance installations. The display is designed for outdoor use, indicating
the number of available parking spaces per parking lot thus guiding motorists to the
closest parking space.
The display has adequate mechanical protection to withstand demanding
environmental conditions and automatic regulation of LED luminance to optimally
adept to surrounding conditions.
environmental conditions and automatic regulation of LED luminance to optimally
adept to surrounding conditions.
SAFETY PRECAUTIONS
The following safety precautions should be observed during normal use, service and
repair:
repair:
x
The SENSIT
Display
may only be installed and serviced by qualified service
personnel.
x
Disconnect the power supply before removing or installing any parts.
x
To be sure of safety, do not modify or add anything to the SENSIT Display
other than mentioned in this manual or indicated by NEDAP N.V.
other than mentioned in this manual or indicated by NEDAP N.V.
DIMENSIONS
In general the SENSIT Display is mounted inside a sign to be part of a (small)
dynamic guidance system. The only requirements are an AC mains power supply and
an Ethernet connection it is also possible to power the display over a PoE+
connection. The ambient light sensor for the automatic regulation of the LED
luminance is located just above the LED’s in the center of the sign. The mounting
dimension can be found below.
dynamic guidance system. The only requirements are an AC mains power supply and
an Ethernet connection it is also possible to power the display over a PoE+
connection. The ambient light sensor for the automatic regulation of the LED
luminance is located just above the LED’s in the center of the sign. The mounting
dimension can be found below.
Figure 39: Dimensions SENSIT DISPLAY (mm).
Note
Make sure the ambient light
sensor isn’t covered.
Note
6x M5x15mm stainless
steel bolts are included