SHENZHEN AOB ELECTRONICS CO. LTD ES-52061BT Manual Do Utilizador

your Bluetooth-enabled smartphone. Press “    ” to answer call; 
Press “    ” to end call.. For best call quality, make sure you are  

Wireless Bluetooth Speaker

Bluetooth-enabled device. You can use the speaker

the speaker can not increase the volume higher than

The speaker can only pair to one device at a

facing the speaker and within 3 feet/1 meter.

speaker can not increase the volume higher than the

would still like to use with the speaker. The

Turn the speaker ON and plug the 3.5mm audio

If Bluetooth-enabled device fails to locate the speaker,

Restart your speaker to reactivate Bluetooth pairing

any other Bluetooth device as the speaker can only

FCC Warning

:

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

---Reorient or relocate the receiving antenna.

---Increase the separation between the equipment and receiver.

---Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

---Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modi

fi

cations to this device not

explicitly approved by manufacturer could void your authority to

operate this equipment.

This device complies with part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired

operation.