Nikko Co Ltd RP6450H Manual Do Utilizador
4
When you connect the connectors make certain the vehicle switch is in
the "OFF" position.
Set connectors properly. ( The connectors are designed to be
Set connectors properly. ( The connectors are designed to be
connected in only one way so that the positive (+) and the negative (-)
terminals are connected accurately. )
Disconnect the connectors immediately after a run.
When you disconnect the connectors, don't pull by the cords.
Avoid short circuits because it is very dangerous.
Remove all the batteries both from the vehicle and the transmitter after
a run.
Disconnect the connectors immediately after a run.
When you disconnect the connectors, don't pull by the cords.
Avoid short circuits because it is very dangerous.
Remove all the batteries both from the vehicle and the transmitter after
a run.
* You can control the vehicle at a longer distance
by holding the transmitter higher with the an
tenna straight up.
by holding the transmitter higher with the an
tenna straight up.
HOW TO PLAY
2
Extend the transmitter antenna.
3
Turn on the transmitter by operating the
control stick.
Battery's Connector
Vehicle's Connector
Band selector switch on transmitter.
Band selector switch on vehicle chassis.
1
Ensure that band selector switch on transmitter and vehicle are set to the same letter
- A, B or C.
27MHz
49MHz
Race 6 cars at once!
3 channels for each frequency, 27MHz, 49MHz, allows up to 6 cars to race at once.